Autel Autolink AL319 - Manual (Page 18)

17
Status Beep Set

The default setting is Beep On.
This function allows you to turn on/off the build-in speaker for the
LEDs in diagnostic testing. Different audio tone corresponds to
different LED lamp. This function is invaluable when working in
bright areas where LED illumination alone is not sufficient.
1) From System Setup screen, use the SCROLL button to select
Status Beep Set and press the ENTER/Exit button.
2) From Status Beep Set menu, use the SCROLL button to select
Beep ON or Beep OFF to turn on/off the beep.
Figure 3.7
3) Press the ENTER/Exit button to save your selection and return
to previous menu.
Tool Self-test
The Tool Self-test function checks if the display, LED lamps and
keyboard are working properly.
A. Display test
The Display Test function checks if the LCD display is working
normally.
1) From System Setup screen, use the SCROLL button to select
Tool Self-test, and press the ENTER/Exit button.
Status Beep Set 1/2
 Beep ON
 Beep OFF