Atec Tektronix-1735 User Manual
Page 5
Input Impedance - >15 kilohm.
Vertical Deflection
Deflection Factor - Within 1% of 1 V.
Variable Gain Range - +5, -20 dB.
Position Range - 1 V signal can be positioned so that peak
white and sync tip can be placed at blanking level regardless
of gain range. Channels 2 and 3 may be offset from channel
1. Channel group B may be offset from channel group A.
Frequency Response
Flat - 50 kHz to 30 MHz within 2%.
Filter - >20 dB attenuation at 20 MHz. Response within 1%
of flat response at 15 kHz.
Transient Response
Overshoot - 1% or less.
Tilt - 1% or less.
DC Restoration
Clamp Point - Back porch.
Mains Hum Attenuation - Slow clamp passes >90% of
50 Hz mains hum (0.9 dB atten.). Fast clamp removes >95%
of 60 Hz mains hum (26 dB atten.).
Blanking Level Shift with 10% to 90% APL Change - 1%
or less.
Picture Monitor Output
Corresponds to waveform display.
Frequency Response - 50 kHz to 30 MHz within 5%.
Differential Gain - <1% at 4.43 MHz.
Differential Phase - <1% at 4.43 MHz.
DC Level on Output - <0.1 V into 75 Ohm load.
Intensification (Brightup) - Approximately 200 mV offset
on select lines.
Output Impedance - 75 Ohm nominal.