Atec TDI-Power-MCL488 - Manual (Page 3)

I NNOVATIVE T EST S YSTEMS ... G LOBAL T EST S OLUTIONS
ANALOG MODE
Ext. Prog: 0 to 10 Volts input yields 0 to full scale loading in
all operating modes.
Input Impedance: 330K Ohms
Prog. Response: Limited by internal adjustable slew rate limiter
Pulse Mode:
Two level or three level pulsing
available in any mode.
Min Pulse
Duration(Any level): 10mSec
Max Pulse
Duration(Any level): 16 Sec or 71 Min. with
reduced resolution and minimum duration
Resolution: 1mSec
Adjustable Slew Rate:
Max:
0 to full scale in 10µS
Min: 0 to full scale in 10mS
OUTPUT SIGNALS
Current Sample Output:
Scaling:
10 Volts = full scale Current
Accuracy: ±0.5% of full scale
PROTECTION
Current Limit: 105% of full scale current
Power Limit: Approximately 370 Watts
Overvoltage: Load disconnect at approximately 105% of full
scale voltage
Thermal: Load disconnect at internal temperature of 105°C
Undervoltage: Load inhibited at less than1 Volt, when enabled
METERS
Voltmeter Accuracy:±0.25%, ±1 Digit
Ammeter Accuracy: ±0.25%, ±1 Digit
Wattmeter Accuracy:
±0.5%, ±2 Digits
IEEE-488 READBACKS
Current:
Resolution:
1/4000 of Full Scale
Accuracy: ±0.5% ±1 Digit
Voltage:
Resolution:
1/4000 of Selected Full Scale
Accuracy: ±0.5% ±1Digit
Power:
Resolution:
87.5 mW
Accuracy: ±0.5% ±1Digit
MECHANICAL
Module Size: 1.58”W x 10.5”H x 24”D
40mm W x 267mm H x 610mm D
Module Weight: 12 lbs. / 5.44kg
Chassis Size:
19”W x 10.5”H x 24”D
483mm W x 267mm H x 610mm D
Rack Mountable
Full Chassis Weight: 125 lbs. / 56.70kg
MISCELLANEOUS
AC Input: User Selectable
110VAC/220VAC,±10%, 48 - 62Hz @ 350W
Ambient Temp: 0°C to 40°C
S
ERIES
S
PECIFICATIONS
C
HASSIS
O
UTLINE