beautypg.com

Atec Sorensen-SL Series User Manual

Page 7

background image

858.458.0223

[email protected]

75 W–14.4 kW

SL Series : Specifications

Common

Software

LabVIEW Driver can be downloaded at no cost: www.elgar.com/products/SL/SL_Downloads.htm

Regulatory

Certified to UL/CSA 61010 and IEC/EN 61010-1, CE Compliant (LVD and EMC Directives)

Environmental

Operating Temperature: 0˚ to 40˚C
Storage Temperature: -10˚ to 65˚C

Cooling

Front, Side, Top Air Inlets, Rear Exhaust, Units may be rackmounted without spacing.

SLH Memory

150 Settings for DC, 5 Settings for AC

Readback

Voltage, Current, Power: 16-bit resolution, VA: Vrms x Arms

Analog Input

SLM: DB9 connector, SLH: BNC connector. DC, Single Input (SLH or SLM), CC Mode: 0-10V = 0 – FS, Bandwidth: 20kHz,
Sums Current with Programmed Value

AC (SLH or SLM)

Sync signal on zero crossing

Remote Programming

SLM-1: RS-232C, GPIB (Optional), SLM-4: RS-232C, GPIB, analog, SLH: RS-232C, GPIB, analog

Dynamic Mode (DC Models)
(see Figure 4)

Mode: CC, T-high, T-low: 50 µs to 9.999 sec, Slew Rate: See Specification Tables, I high, I low: 0 to Rated Current

Options and Accessories

-1: GPIB, SLM-1 or SLM-4 only
-01: 100/200V AC input, SLM-1 only
-11: 100/200V AC input and GPIB
M12: Front panel bus bar, SLH DC only
M23: Front panel bus bar and 100/200V AC Input, SLH DC only

Input Power

Line:

115V / 230V ± 10%, switch selectable or 100V / 200V ± 10% switch selectable (optional)

Frequency:

50 / 60Hz

Power Consumption

100W Maximum

Protection: AC input fuses

OVP, OCP, OPP:

~5% above rated maximum

OTP:

~85°C Heat sink temperature

DC Loads:

Reverse Polarity All protection modes turn off LOAD input

Hardware Input Voltage Limit:

60V Rated DC Input: 100V, 250V Rated DC Input: 400V, 500V Rated DC and all AC Input: 900V

SLM Chassis

Memory

150 memory settings for DC modules, 5 memory settings for AC modules, Memory settings store entire chassis condition

Sequencer (see Figure 2)

Control

Front panel

Timing

100ms-9.9 secs per step

Maximum Steps per Sequence

16

Number of Sequences

9

Programming

All Parameters

12-bit resolution

AC Crest Factor (see Figure 3)

Sinewave: √2, 1.5-3.5, Resolution: 0.1
Squarewave: 1.0-3.4, Resolution: 0.1

DC

√2, 2.0-3.5, Resolution: 0.5

Maximum Peak

Current = 2 x Rated Current

Fig.2 - Sequencer for Modules

Fig.3 - Crest Factor for AC models

Fig.4 - Dynamic Mode for DC models

265