Dhp 30, Mxx), Dhp series – Atec Sorensen-DHP Series User Manual
Page 5: 5–20 kw
858.458.0223
Model Number Description
DHP 30
Series
Voltage
220
Amperes
(MXX)
Options
Software
LabVIEW® driver for M9D, programs can be downloaded at no cost at : http://www.elgar.com/products/DHP/DHP_Downloads.htm
DHP Series
Options and Accessories
M1
360-440 VAC, 47-63 Hz, three phase, 3-wire plus ground, Delta or Wye may be used
M2
432-528 VAC, 47-63 Hz, three phase, 3-wire plus ground, Delta or Wye may be used
M8
Internal RS-232 remote serial interface
M9D
Internal IEEE-488.2 interface
M10
Both IEEE-488.2 and RS-232
M11
RS-232 and isolated analog programming
M12
IEEE-488.2 and isolated analog programming
M14
IEEE-488.2, RS-232 and isolated analog programming
M51
Isolated analog programming Input Voltage Options. This isolation allows users to control power supplies not connected to
a common ground. In addition, in systems with high ambient noise or with large ground loop currents the control ground
can be isolated from the power ground eliminating problems.
5–20 kW
© 2009 AMETEK Programmable Power All rights reserved. AMETEK Programmable Power is the trademark of AMETEK Inc., registered in the U.S. and other countries.
Elgar, Sorensen, California Instruments, and Power Ten are trademarks of AMETEK Inc., registered in the U.S.
75