Atec JDSU-JD748A-JD788A - Manual (Page 5)

5
Spectrum Analyzer
100 kHz to 4 GHz (JD748A)
9 kHz to 8 GHz (JD788A)
Built-in pre-amplifier
Zero span with gate sweep Locates and identifies various signals over frequency ranges up to
4 GHz/8 GHz.
Detects signals as low as –160 dBm/–165 dBm with better than 1 dB
measurement accuracy.
Triggers pulse or burst signal such as WiMAX, GSM, and TD-SCDMA.
RF Power Meter
10 MHz to 4 GHz (JD748A)
10 MHz to 8 GHz (JD788A) Integrated RF power meter eliminates the need for a separate instrument
and measures power with or without a power sensor.
2-Port Transmission
Measurements*
(option 001)
Verifies passive and active devices, such as filters and amplifiers.
CW Signal Generator*
(option 003) Provides a sine wave or continuous wave (CW) source for measurements
such as isolating a repeater.
GPS Receiver and Antenna
(option 010) Provides geographical location, highly accurate frequency, and time for
precise measurements.
Interference Analyzer
(option 011) Provides the required spectrogram and multisignal RSSI parameters to
properly monitor, identify, and locate interference signals. In addition, it
can generate a variable audible tone based on signal strength.
Channel Scanner
(option 012) Intuitive graphical representation of the signal’s power for each of the 20
user-definable carriers (frequencies or channels) for quick identification of
improper power levels.
Optical Power Meter
(option 013) Measures optical power for all single-mode and multimode connectors via
an optional optical power sensor (MP60 or MP80).
Signal Analyzer
(options 020 to 029) Provides 3GPP/3GPP2/IEEE802.16 conformance testing for RF characteris-
tics as well as modulation analysis of 2G to 4G wireless technologies.
Over-the-Air Analyzer
(options 040 to 049) Characterizes transmission quality at any location providing reflective
measurements and identifying signals transmitted from various sites.
*Only available for the JD788A