Atec JDSU-JD748A-JD788A - Manual (Page 12)

12
Signal Analyzer
The Signal Analyzer performs 3GPP/3GPP2/IEEE802.16-standard RF compliance test-
ing for power and spectrum as well as modulation analysis. It performs standards-based
measurements with a single-button push, indicating pass/fail based on standards or
user-defined limits.
The Auto Measure capability lets users easily set up test scenarios with programmed
measurement schedules such as start time, test duration, test cycles, and test metrics.
Then, based on the user-defined conditions, the analylzer tests up to 10 different carriers
and automatically saves the corresponding results.
The Over The Air (OTA) Analyzer function provides OTA measurements to quickly
perform base station characterization. This measurement capability is especially useful
for testing cell sites without interrupting service are those that are not easily accessible.
The Signal Analyzer provides these measurement capabilities:
• Spectrum analysis
• RF analysis
• Modulation analysis
• Auto measure
Modulation analysis can be performed for these wireless technologies:
• cdmaOne/cdma2000 (option 020)
• EV-DO (option 021)
• GSM/GPRS/EDGE (option 022)
• WCDMA/HSPA+ (option 023)
• TD-SCDMA (option 025)
• Mobile WiMAX (option 026)
• LTE - FDD (option 028)
• LTE - TDD (option 029)
Over-the-air (OTA) analyses include:
• cdmaOne/cdma2000 (option 040)
• EV-DO (option 041)
• GSM/GPRS/EDGE (option 042)
• WCDMA/HSPA+ (option 043)
• TD-SCDMA (option 045)
• Mobile WiMAX (option 046)
• LTE - FDD (option 048)
• LTE - TDD (option 049)