Specifications of antennas – Atec Narda-IDA-3106 User Manual
Page 12
SPECIFICATIONS OF ANTENNAS
DIRECTIONAL ANTENNA 2 (3100/12)
Frequency range
200 MHz to 500 MHz
Typical antenna factor correction is applied automatically when used in conjunction with the
IDA basic unit and Narda Active Antenna Handle
Antenna type
Dipole antenna
Antenna factor
23 dB(1/m) typical @ 300 to 400 MHz
DIRECTIONAL ANTENNA 3 (3100/13)
Frequency range
400 MHz to 6 GHz
Typical antenna factor correction is applied automatically when used in conjunction with the
IDA basic unit and Narda Active Antenna Handle
Antenna type
Log-periodic antenna
Antenna factor
20 dB(1/m) typical @ 600 MHz
ACTIVE ANTENNA HANDLE (3100/10) - WITH ELECTRONIC COMPASS AND PREAMPLIFIER
Frequency range
20 MHz to 6 GHz (preamp off: 9 kHz to 6 GHz)
Frequency response correction is applied automatically when used in conjunction with the
IDA basic unit.
Preamplifier
Built in, can be switched off
Amplification 20 dB, noise figure < 6 dB
Compass
Embedded electronic compass, uncertainty < 1.5° RMS (typ.) for tilt <15°
Pitch- and roll uncertainty < 3° RMS (typ.) in the range of +/- 30°
Connection cable to IDA basic unit
RF cable and control cable combined in a flexible tube, length of 1 meter
RF connector to basic unit
N-connector, male, 50 Ω
RF connector to Narda directional antennas
BMA 50 Ω, (female on handle side)
Antenna connectivity
Narda antennas can be plugged in with horizontal and vertical polarization. Type of antenna
and polarization detected automatically and transferred to basic unit
Power supply
From basic unit
Mounting
Connecting thread on the underside of the handle for tripod mounting
DIRECTIONAL ANTENNA 1 (3100/11)
Frequency range
20 MHz to 250 MHz
Typical antenna factor correction is applied automatically when used in conjunction with the
IDA basic unit and Narda Active Antenna Handle
Antenna type
Loop antenna
Antenna factor
21 dB(1/m) typical @ 200 MHz
GENERAL SPECIFICATIONS - ANTENNA HANDLE AND ANTENNAS
Operating temperature range
-10 °C to +50 °C
Storage
1K3 (IEC 60721-3) extended to -10 °C to +50 °C
Transport
2K4 (IEC 60721-3)
Climatic
Operating
7K2 (IEC 60721-3) extended to -10 °C to +50 °C
Storage
1M3 (IEC 60721-3)
Transport
2M3 (IEC 60721-3)
Mechanical
Operating
7M3 (IEC 60721-3)
ESD and EMC
EN 61326:2006
Safety
EN 61010-1:2002
EU Guidelines
2003/11/EG 06.02.2003 (PBDE and OBDE)
2002/95/EG 27.01.2003 (RoHS), 2002/96/EG 27.01.2003 (WEEE)
Compliance
CE (European Community)
Yes
Air humidity
< 29 g/m³ (< 93 % at +30 °C)
Active Antenna Handle
165 mm length; 165 mm height; 43 mm width, weight: 450 g (w/o cable)
Directional Antenna 1
325 mm length; 255 mm height; 80 mm width, weight: 450 g
Directional Antenna 2
285 mm length; 410 mm height; 43 mm width, weight: 350 g
Dimensions
Directional Antenna 3
460 mm length; 320 mm height; 48 mm width, weight: 400 g
Country of origin
Germany
NSTS 0911-E0280B
12 / 14
Subject to change without notice