Atec HP-Agilent-8110A - Manual (Page 3)

3
Specifications
Specifications describe the instrument's warranted performance. Non-warranted values are described as typical. All specifications apply
after a 30 minute warm-up phase with 50
Ω source/load resistance and separate channels. All specifications are valid from 0°C to 55°C
ambient temperature.
Timing Characteristics
Measured at 50% amplitude at fastest transitions in continuous mode and 50 Ω source impedance.
Burst Count: 2 to 65536 (single or
double pulses).
Delay: delay, phase or % of period.
Fixed delay: 34 ns typical
Double pulse and delay:
mutually exclusive.
Duty cycle: set between 0.1% and
94.0% (subject to width limits.
99.9% with overprogramming).
Repeatability: is typ. four times
better than accuracy.
Transition times: leading/ trailing edge
or % of width. Leading and trailing
edges are independent within one of
the following
overlapping segments
(1:20 ratio): 2 ns (3 ns) - 20 ns,
10 ns - 200 ns, 100 ns - 2 ms,
1µs - 20 µs, 10 µs - 200 µs,
100 µs - 2 ms, 1 ms - 20 ms,
10 ms - 200 ms.
Overprogramming: values can be
entered exceeding the specified
range.
Mainframe
Output module
Agilent 8110A
Agilent 81103A
Agilent 8110A
Agilent 81103A with 81106A PLL
Frequency range 1 Hz to 150 MHz 1 mHz to 150 MHz
Timing resolution 3 digits, 10 ps best case 4 digits, 10ps best case
RMS jitter (period, width, delay) 0.03% + 25 ps 0.003% + 20 ps
Period range 6.65 ns to 999 ms 6.65 ns to 999 s
Accuracy ± 5% ± 100ps ± 0.1%
Width range 3.30ns to (period – 3.3 ns), maximum 999ms
Accuracy ± 5% ± 250 ps
Add. variable delay range [1] 0.00 ns to (period – 6.6 ns), maximum 999 ms
Accuracy ± 5% ± 1 ns
Double pulse delay range 6.65ns to (period - width - 3.3 ns), maximum 999 ms
Min. period 13.3 ns (75 MHz)
Accuracy ± 5% ± 250 ps
Transition time range (10/90) 2.00 ns to 200 ms variable
Minimum
(with overprogramming)
≤ 2.0 ns for levels within ± 5 V window.
< 2.5 ns for all levels
1.4 ns typ. for ECL levels (20/80)
Accuracy ± 10 % ± 200 ps
Linearity 3% typ. for transitions > 100 ns
Notes:
[1] Additional 0 ns to 28 ns delay range with the Agilent 81107A Multichannel