Atec Rohde-Schwarz-ZNC - Manual (Page 9)

Version 03.00, September 2012
Rohde & Schwarz R&S ® ZNC Vector Network Analyzer 9
Test port input
Match without system error correction
9 kHz to 50 kHz > 10 dB
50 kHz to 3 GHz > 20 dB
Maximum nominal input level +13 dBm
Power measurement accuracy at –10 dBm without power calibration
9 kHz to 100 kHz < 2 dB
100 kHz to 3 GHz < 1 dB
Receiver linearity referenced to –10 dBm
for +20 dB to +10 dB
9 kHz to 3 GHz < 0.2 dB
for +10 dB to –40 dB
9 kHz to 3 GHz < 0.2 dB
Damage level +27 dBm
Damage DC voltage 30 V
Noise level at 1 kHz measurement bandwidth, normalized to 1 Hz
9 kHz to 100 kHz
< –105 dBm (1 Hz)
100 kHz to 3 GHz < –120 dBm (1 Hz)
The noise level is defined as the RMS value of the specified noise floor.
Additional front panel connectors
USB (four) universal serial bus connectors for connecting USB devices (USB 2.0)
Display
Screen 30.7 cm (12.1") diagonal WXGA color LCD with touchscreen
Resolution 1280 Ч 800 Ч 262144 (high color, 125 dpi)
Pixel failure rate < 1 × 10 –5
Rear panel connectors
GPIB optional remote control in line with IEEE 488, IEC60625; 24-pin
LAN local area network connector, 8-pin, RJ-45
10 MHz REF either input or output for external frequency reference signal
Connector type BNC, female
Input frequency range 1 MHz to 20 MHz in steps of 1 MHz
Maximum permissible deviation 1 kHz
Input power –10 dBm to +15 dBm
Input impedance 50 Ω
Output frequency 10 MHz
Output frequency accuracy 80 Hz
Output power +9 dBm ± 4 dB at 50 Ω
MONITOR DVI connector (for external monitor)