Atec Pacific-Power-M6204 - Manual (Page 3)

IEC Flicker Impedance
IEC Impedance
Parameter
Specification Unit Conditions
Resistive
Phase A 0.24 Ω
Phase B 0.24 Ω
Phase C 0.24 Ω
Neutral 0.16 Ω
Accuracy ± 0.002 Ω Internal Calibration
Inductive
Phase A 0.15j Ω
Phase B 0.15j Ω
Phase C 0.15j Ω
Neutral 0.10j Ω
Accuracy < 2%
Voltage
Max. 300.0 Vrms
Current
Max. 16.0 Arms
Power
Max. 4000 VA / W Per Phase
Terminals No of Terminal Positions Designator
AC Input - Power Source 3 Phase + Neutral Terminal Block -1 Rear Panel, Connect to AC Source Output
Recommended Wire Size: 6 AWG
AC Output - UUT 3 Phase + Neutral Terminal Block -3 Rear Panel, Connect to UUT AC Input
Recommended Wire Size: 6 AWG
AC Voltage Sense 3 Phase + Neutral Terminal Block -2 Rear Panel, Connect to AC Source External Voltage Sense
Recommended Wire Size: 20 AWG
AC Output - UUT Sense 3 Phase + Neutral Terminal Block -4 Connects to Flicker Meter or Power Analyzer Inputs
Recommended Wire Size: 20 AWG
Cooling Fan Power Cable Harness J20A/P20A Interface Cable to AC Source Included
Ground Screw Stud GND Chassis Ground Required
Ratings
Input Power Requirments
M6204
DC Input
Parameter
Specification Unit Conditions
Fan
Voltage (nominal) 24 Vdc
DC Power provided by AC Power Source through included P20A/J20A Interface cable.
Current @ 24 Vdc 0.28 Adc
Fan Axial Dual Ball bearing
Size 120 mm
1 If a NON Pacific Power Source AC Power Source model is used with the M6204, an external 24Vdc supply capable of supplying 280 mAdc @ 24Vdc is required to oper-
ate the Fan.