Atec National-Instruments-NI-ELVIS - Manual (Page 3)

Waveform Editor
Amplitude............................................ ±10 V
Frequency range.................................. DC to 100 kHz 1
Output drive current............................ 25 mA max
Output impedance............................... 1
Slew rate............................................. 1.5 V/µs
Power Supplies
+15 V
Output current ..................................... Self-resetting circuitry, not to
shut down at or below 500 mA
Output voltage .................................... 15 V at ±5% no load
Line regulation .................................... 0.5% max
Load regulation ................................... 1% typ, 5% max 0 to full load 2
Ripple and noise ................................. 1%
-15 V
Output current ..................................... Self-resetting circuitry, not to
shut down at or below 500 mA
2
Output voltage .................................... -15 V at ±5% no load
Line regulation .................................... 0.5% max
Load regulation ................................... 1% typ, 5% max 0 to full load 2
Ripple and noise ................................. 1%
+5 V
Output current ..................................... Self-resetting circuitry, not to
shut down at or below 2 A
Output voltage .................................... +5 V at ±5% no load
Line regulation .................................... 0.50% max
Load regulation ................................... 22% typ, 30% max 0 to full load 2
Ripple and noise ................................. 1%
Variable Power Supplies
0 to +12 and -12 V
Ripple and noise ................................. 0.25%
Software resolution ............................ 7 bits
Current limiting ................................... 0.5 V at 130 mA, 5 V at 275 mA,
12 V at 450 mA
1 Specification depends on data acquisition device functionality.
2 Proper null correction at the common-mode voltage can reduce ±3 mA error to 200 µA noise.
Safety and Compliance
Safety
This product is designed to meet the requirements of the following
standards of safety for electrical equipment for measurement, control,
and laboratory use:
• IEC 61010-1, EN 61010-1
• UL 61010-1, CAN/CSA-C22.2 No. 61010-1
Note: For UL and other safety certifications, refer to the product label
or visit
ni.com/certification , search by model number or product line,
and click the appropriate link in the Certification column.
Electromagnetic Compatibility
This product is designed to meet the requirements of the following
standards of EMC for electrical equipment for measurement, control,
and laboratory use:
• EN 61326 EMC requirements; Minimum Immunity
• EN 55011 Emissions; Group 1, Class A
• CE, C-Tick, ICES, and FCC Part 15 Emissions; Class A
Note: For EMC compliance, operate this device according to
product documentation.
CE Compliance
This product meets the essential requirements of applicable European
Directives, as amended for CE marking, as follows:
• 73/23/EEC; Low-Voltage Directive (safety)
• 89/336/EEC; Electromagnetic Compatibility Directive (EMC)
Note: Refer to the Declaration of Conformity (DoC) for this product for
any additional regulatory compliance information. To obtain the DoC for
this product, visit
ni.com/certification , search by model number or
product line, and click the appropriate link in the Certification column.
Waste Electrical and Electronic Equipment (WEEE)
EU Customers: At the end of their life cycle, all products must be
sent to a WEEE recycling center. For more information about WEEE
recycling centers and National Instruments WEEE initiatives, visit
ni.com/environment/weee.htm .
NI Educational Laboratory Virtual Instrumentation Suite (NI ELVIS)
3
BUY ONLINE at ni.com or CALL (800) 813 3693 (U.S.)