Atec National-Instruments-NI-ELVIS - Manual (Page 2)

Specifications
Analyzers
Oscilloscope
Channels.............................................. 2
Data storage, cursors, autoscaling
Max input bandwidth ..................... 50 kHz 1
Max sampling rate ......................... 500 kHz/channel 1
Range .............................................. ±10 V
Input resolution............................... 12, 16, or 18 bits 1
Bode Analyzer
Frequency and phase plots
Frequency range and step control
Logarithmic or linear frequency spacing
Data storage, cursors, autoscaling
Frequency range ............................. 5 Hz to 35 kHz 1
Dynamic Signal Analyzer
Input range .......................................... ±10 V
Input resolution ................................... 12, 16, or 18 bits 1
Impedance Analyzer
Measurement frequency range .......... 5 Hz to 35 kHz
2-Wire Current Voltage Analyzer
Voltage range...................................... ±10 V
Current range ...................................... ±10 mA
3-Wire Current Voltage Analyzer
NPN BJT transistor only
Data storage, cursors, autoscaling
Maximum collector voltage............ 10 V
Base current resolution .................. 1 µA (16-bit analog output)
15 µA (12-bit analog output)
Digital Multimeter
Resistance
Accuracy.............................................. 1%
Range .................................................. 5 Ω to 3 M Ω
DC Voltage
Accuracy.............................................. 0.3%
Range .................................................. ±20 V
Input impedance ................................. 1 M Ω
AC Voltage
Accuracy.............................................. 0.3%
Range .................................................. ±14 V
rms
Current
DC accuracy ........................................ 0.25% ±3 mA 2
AC accuracy ........................................ 0.25% ±3 mA 2
Range .................................................. ±250 mA
Shunt resistance ................................. 0.5 Ω
Maximum common-mode voltage ...... ±20 V
Common-mode rejection..................... 70 dB
Capacitance
Accuracy.............................................. 2%
Range .................................................. 50 pF to 500 µF
Test voltage range .............................. 1 V
pp
Continuity
Resistance threshold .......................... 15 Ω max
Inductance
Accuracy.............................................. 1%
Range .................................................. 100 µH to 100 mH
Test frequency..................................... 950 Hz
Test frequency voltage........................ 1 V
pp
Digital I/O
Digital input resolution ....................... 8 bits
Digital output resolution..................... 8 bits
Digital addressing ............................... 4 bits
Source
Function Generator
Manual or software control
Sine, triangle, square waveforms
Frequency sweep
TTL sync pulse out
AM, FM modulation
Frequency range ............................. 5 Hz to 250 kHz
Frequency accuracy ........................ 3%
Output amplitude............................ ±2.5 V
Software amplitude resolution ...... 8 bits
Offset range.................................... ±5 V
AM voltage ..................................... 10 V max
Amplitude modulation .................... Up to 100%
FM voltage...................................... 10 V max
Amplitude Flatness
To 50 kHz ............................................. 0.5 dB
To 250 kHz ........................................... 3 dB
Arbitrary Waveform Generator
Channels.............................................. 2, 1-shot or
continuous generation
1 Specification depends on data acquisition device functionality.
2 Proper null correction at the common-mode voltage can reduce ±3 mA error to 200 µA noise.
NI Educational Laboratory Virtual Instrumentation Suite (NI ELVIS)
2
BUY ONLINE at ni.com or CALL (800) 813 3693 (U.S.)