Atec Fluke-Optifiber-OTDR - Manual (Page 7)

Additional Key specifications
FiberInspector probe specifications
Magnification ~ 200X with OptiFiber Pro Display
Light source Blue LED
Power source TFS mainframe
Field of View (FOV) Horizontal: 425 µm, Vertical: 320 μm
Minimum detectable particle size 0.5 µm
Dimensions Approximately 6.75 in x 1.5 in (1175 mm x 35 mm) without adapter tip
Weight 200 g
Temperature range Operating: 32°F to 122°F (0 °C to +50 °C), Storage: -4°F to +158°F (-20°C to +70°C)
VFL specifications
On/Off control Mechanical switch and a button on the touch screen
Output power 316 µW (-5 dBm) ≤ peak power ≤ 1.0 mW (0 dBm)
Operating wavelength 650 nm nominal
Spectral width (RMS) ±3 nm
Output modes Continuous wave Pulsed mode (2 Hz to 3 Hz blink frequency)
Connector adapter 2.5 mm universal
Laser safety (classification) Class II CDRH Complies to EN 60825-2
For complete kit configurations, please visit www.flukenetworks.com/orderopro
Technical specifications
General specifications
Weight Mainframe with module and battery: 3 lbs, 5 oz (1.28 kg)
Dimensions Mainframe with module and battery: 2.625 in x 5.25 in x 11.0 in ( 6.67 cm x 13.33 cm x 27.94 cm)
Battery Lithium ion battery pack, 7.2 volts
Battery life 8 hr Auto OTDR operation, dual wavelength no video probe connected, 150 m of fiber
Charge Time
Tester off 4 hours to charge from 10% to 90% capacity
Tester on 6 hours to charge from 10% to 90% capacity with the tester on
Environmental specifications
Operating temperature* -18ºC to 45ºC
Non-operating temperature -30ºC to 60ºC
Operating altitude 4,000 m (13,123 ft), 3,200 m (10,500 ft) with AC adapter
Storage altitude 12,000 m
EMC EN 61326-1
Using battery power. With AC power: 0ºC to 45ºC. Real Time Trace function used for no more than 5 minutes in a 15-minute period. Maximum ambient
temperature is 35ºC for continuous use of the Real Time Trace function.
Do not keep battery at temperatures below -20°C (-4°F) or above 50°C (122°F) for periods longer than one week to maintain battery capacity.
7 of 9