Atec Fluke-Optifiber-OTDR - Manual (Page 3)

Extremely short event and attenuation dead zone
The OptiFiber Pro leverages the most sophisticated optical technology to provide the shortest event dead zone (0.5 m typical for MM) and
attenuation dead zone (2.5 m typical for MM and 3.6 m typical for SM) of any OTDR. This technological advancement allows OptiFiber Pro to
detect and measure closely spaced faults where no other OTDR can in today’s connector-rich datacenter and storage area network
environments.
Two second trace per wavelength
Another breakthrough with OptiFiber Pro is the data acquisition speed. While in Quick Test mode, a complete set of data is acquired in as little as
two seconds per wavelength. OptiFiber Pro then analyzes the data and displays it as an EventMap event, Table or Trace. The end result is less
time spent testing and more time performing other tasks.
DataCenter OTDR™ mode
With a simple one-touch selection, users enter DataCenter OTDR mode – without setup time for fine tuning as needed in legacy OTDRs.
DataCenter OTDR mode automatically detects OTDR parameters – end-detection algorithms, pulse widths – without getting confused by the
short links or number of connectors.
Extremely short event and attenuation dead zone
DataCenter OTDR mode
3 of 9