Atec Narda-8700-8741d-8754D-8760D-8761D - Manual (Page 6)

542
USA TEL: (1) 631 231-1700 • INT’L TEL: (1) 631 231-1390 • FAX (1) 631 231-1711
E-MAIL: [email protected] • www.nardamicrowave.com
Electric and Magnetic Field Measurement
RF Radiation
Safety Products
Power
Meters/Monitors
Wireless
Products
Electromechanical
RF Switches
Passive
Components
Active
Components
MAGNETIC FIELD PROBES
MODEL
NO.
FREQUENCY RANGE
MEASUREMENT RANGE
SHAPE SENSOR TYPE
RATED A/M A 2 /m 2
8752D
300 kHz to 10 MHz
100mW/cm 2 to
200mW/cm 2
0.0515 to
2.31
0.00265 to
5.31
FLAT Thermocouple
8754D
1mW/cm 2 to
2 W/cm 2
0.163 to
7.29
0.0275 to
53.1
A8732D 300 kHz to 200 MHz
0.3% to 300%
of Standard
—— —— Shape 5 d Thermocouple
8731D
10 MHz to 300 MHz
10mW/cm 2 to
20mW/cm 2
0.0163 to
0.729
0.000265 to
0.667
FLAT Thermocouple
8733D
50mW/cm 2 to
100mW/cm 2
0.0364 to
1.64
0.00167 to
2.66
a Frequency sensitivity can be compensated for by the use of the calibration factors marked on the handle of each probe
b
In power (10 log
10
units)
c The fields generated to calibrated the probes are accurate within ±0.5dB.
d See probe selection guide on page 539
8700 SERIES CONNECTOR TYPES
The latest 8700 system equipment uses a new, quick re-
lease style 8-pin connector, referred to as “Type L.” Older
models and the 8700 series meters use a 7-pin, screw
type connector, referred to as “Type A.”
Most older style 8700 series probes featured integral ca-
bles. The new D series probes require the use of a sepa-
rate cable. One cable is required for each meter,
regardless of the number of probes. A four foot long
(1.2 m) quick-release cable (Model 8844-04) is supplied
with every hand-held meter. The 8717 series meter
requires the 8743-XX style cable which must be ordered
separately. The 8740 style cables can be used to extend
the length of the 8743 style cables.
Type L Male Cable Connector
Type A Male Cable Connector
Main
Menu
TOC