Atec Narda-8700-8741d-8754D-8760D-8761D - Manual (Page 4)

540
USA TEL: (1) 631 231-1700 • INT’L TEL: (1) 631 231-1390 • FAX (1) 631 231-1711
E-MAIL: [email protected] • www.nardamicrowave.com
Electric and Magnetic Field Measurement
RF Radiation
Safety Products
Power
Meters/Monitors
Wireless
Products
Electromechanical
RF Switches
Passive
Components
Active
Components
MODEL
NO.
FREQUENCY
RANGE
MEASUREMENT RANGE
FREQUENCY
RESPONSE
SENSOR
TYPE Rated V/m V 2 /m 2
8782D a 3 kHz to 1 MHz
0.1mW/cm 2 to
200mW/cm 2
0.61 to 868
0.376 to
753,000
Flat Active Antenna
8764D 100 kHz to 300 MHz
100mW/cm 2 to
200mW/cm 2
19.4 to 868 376 to 753,000
Flat
Compensated
Diode
8760D
300 kHz to 3.0 GHz
0.05mW/cm 2 to
100mW/cm 2
0.5 to 19.4 0.2 to 377
8761D
10mW/cm 2 to
20mW/cm 2
6.13 to 274 37.6 to 75,300
8762D
100mW/cm 2 to
200mW/cm 2
19.4 to 868 376 to 753,000
A8742D
0.6 to 600%
of Standard
— —
Shaped g
B8742D Shaped g
8741D
300 kHz to 50 GHz
50mW/cm 2 to
20mW/cm 2
13 to 274 169 to 75,300 Flat
Compensated
Diode
and
Thermocouple
A8722D
0.3% to 300%
of Standard
— — Shaped g
B8722D
C8722D
D8722D
8721D
300 MHz to 50 GHz e
10mW/cm 2 to
20mW/cm 2
6.13 to 274 37.6 to 75,300
Flat Thermocouple
8723D
50mW/cm 2
100mW/cm 2
13.7 to 614 188 to 376,000
8783D
8725D 1 to 40 GHz e
0.5 mW/cm 2 to
1000mW/cm 2 43.4 to 1940
1880 to
3,760,000
8781D 2 to 18 GHz
20mW/cm 2 to
20mW/cm 2
8.67 to 274
75.3 to 75,300
a
Model 8782D probe must be used with fiber optic interface Model 8747. Specifications guaranteed for high power range only.
b Frequency sensitivity can be compensated for by the use of calibration factors marked on the handle of each probe
c In power (10 log
10
) units
d The fields generated to calibrate the probes are accurate within ±0.5 dB
e
This model can be used up to 100 GHz. Refer to the application note on pages 618
f Isotropic response ±1 dB from 300 kHz to 3 MHz
g See Shaped Probe Selection Guide on previous page
ELECTRIC FIELD PROBES
Main
Menu
TOC