Atec Agilent-N9343C - Manual (Page 6)

6
Specifi cations (continued)
Sweep specifications Supplemental information
Sweep time
Range 2 ms to 1000 s Span ≥ 100 Hz
600 ns to 200 s Span = 0 Hz (zero span)
Sweep mode Continuous, single
Sweep time rule Accuracy, speed
Trigger source Free run, video, external, RF burst
Trigger slope Selectable positive or negative edge
Trigger delay ± 12 ms to ± 12 s Nominal, span = 0 Hz (zero span)
Front panel input/output Supplemental information
RF input
Connector and impedance Type-N female, 50 Ω Nominal
10 MHz reference/external trigger input
Reference input frequency 10 MHz
Reference input amplitude 0 to +10 dBm
Trigger voltage 5 V TTL level Nominal
Connector BNC female, 50 Ω Nominal
Probe power
Voltage/current +15 Vdc, ± 7% at 0 to 150 mA (nominal)
-12.6 Vdc, ± 10% at 0 to 150 mA (nominal)
GND
Connectivity
USB host USB Type-A female, compatible with USB
2.0 full speed
USB device USB Type-mini AB female, compatible
with USB 2.0 full speed
LAN RJ-45, 10 Base-T
General specifications Supplemental information
Display
Resolution 640 pixels x 480 pixels
Size and type 170 mm (6.5 in) TFT color display
Languages
On-screen GUI English, Simplified Chinese, Traditional
Chinese, French, German, Italian,
Japanese, Korean, Russian, Spanish,
Portuguese
Power requirements and calibration
Adaptor voltage 100 to 240 V AC, 50 to 60 Hz Auto-ranging
15 V DC, 5.3 A, 80 W max
Power consumption 16 W Typical
Battery operating time (fully charged
battery) 3.5 hours Tracking generator off, preamplifier on
3 hours Tracking generator on, preamplifier on
Charging time 3 hours
Life time 300 to 500 charge cycles
Warm-up time 30 minutes
Calibration cycle One year