Atec Agilent-33600A Series - Manual (Page 16)

16
Waveform characteristics, continued
R E V O L U T I O N A R Y S I G N A L F I D E L I T Y W I T H U N M A T C H E D C A P A B I L I T I E S
Square & pulse
Frequency ranges
V
OUt
≤ 10 Vpp 1 µhz to 50 Mhz, 1-µhz resolution
V
OUt
≤ 4 Vpp 1 µhz to 100 Mhz, 1-µhz resolution 1
Rise & fall time (nom) Square Pulse
V
OUt
≤ 4 Vpp 2.9 ns 2.9 ns to 1 ms, independently variable, 100-ps resolution
V
OUt
> 4 Vpp 4.0 ns 3.3 ns to 1 ms, independently variable, 100-ps resolutio
Overshoot (typ) Square Pulse, min. edge Pulse, 4-ns edge Pulse, ≥ 6-ns edge
V
OUt
≤ 4 Vpp < 4% < 4% < 2% < 2%
V
OUt
> 4 Vpp < 4% < 7% < 4% < 2%
Duty cycle 6 0.01% to 99.99%, 0.01% resolution
Pulse width
V
OUt
≤ 4 Vpp 5 ns minimum (high or low), 1-ps resolution
V
OUt
> 4 Vpp 8 ns minimum (high or low), 1-ps resolution
Jitter (rms) (meas) 7 Standard Opt OCX
10-hz to 40-Mhz band 1 ps 0.5 ps
Ramp & triangle
Frequency range 1 µhz to 800 khz, 1-µhz resolution
Ramp symmetry 0% to 100%, 0.1% resolution, (0% is negative ramp, 100% is positive ramp, 50% is triangle)
Nonlinearity (typ) < 0.05% from 5% to 95% of the signal amplitude
Gaussian noise
Variable bandwidth (nom)
V
OUt
≤ 10 Vpp 1 mhz to 60 Mhz
V
OUt
≤ 8 Vpp 1 mhz to 80 Mhz
V
OUt
≤ 4 Vpp 1 mhz to 120 Mhz 1
Crest factor (nom) 4.6
Repetition period > 100 years
Pseudorandom binary sequence (PRBS)
Bit rate
V
OUt
≤ 10 Vpp 1 mbps to 100 Mbps, 1-mbps resolution
V
OUt
≤ 4 Vpp 1 mbps to 200 Mbps, 1-mbps resolution 1
Sequence length 2m-1, m = 3 to 32
Rise & fall time (nom)
V
OUt
≤ 4 Vpp 2.9 ns to 1 ms, independently variable, 100-ps resolution
V
OUt
> 4 Vpp 3.3 ns to 1 ms, independently variable, 100-ps resolution
Arbitrary waveforms
Waveform length 32 Sa to 4 MSa per channel (64 MSa with Option MeM) in increments of 1 Sa
Sample rate (F
S
)
33611a/12a 1 µSa/s to 660 MSa/s, 1-µSa/s resolution 8
33621a/12a 1 µSa/s to 1 GSa/s , 1-µSa/s resolution 8
Voltage resolution 14 bits
Waveform filters “Normal” (highest bandwidth, ~5% preshoot and overshoot),
“Step”
(lower bandwidth, ~0% preshoot or overshoot), or
“Off” (transitions from point to point occur as quickly as possible)
Frequency and time characteristics Filter = “Normal” Filter = “Step” Filter = “Off”
Bandwidth (-3 dB)(nom) 0.27 x F
S
(100 Mhz max) 0.13 x F
S
(100 Mhz max) 100 Mhz
Rise & fall time (nom) 0.35 / bandwidth (3.5 ns min) 0.35 / bandwidth (3.5 ns min) 3.5 ns
Jitter (rms) (meas) 8 < 2 ps < 1 ps < 10 ps
Footnotes referenced on page 22