Atec AE-Techron-7796 - Manual (Page 3)

7796 Datasheet Information subject to change.
1/28/2013
DC Drift:
7796: ±1.5 mV
7796P: ± 400 µV (from cold to
maximum operating temperature);
±200 µV (after 20 minutes of
operation)
Residual Noise:
Unfiltered: Less than 75 μV
Filtered (400 Hz – 30 kHz):
Less than 55 μV
THD:
DC - 30 kHz less than 0.1%
Input Characteristics
Balanced with ground:
Three terminal barrier block connector
20k ohm differential
Unbalanced:
BNC connector, 10k ohm single ended
Gain:
Voltage Mode: 20 volts/volt
Current Mode: 20 amperes/volt
Gain Linearity (over input signal, from
0.2 V to 5 V):
7796: 0.1%
7796P:
DC: 0.0125%
AC: 0.030%
Max Input Voltage:
± 10 V balanced or unbalanced
Input Impedance:
20 kOhm differential
Input Sensitivity:
3.0V input for 3800W output into 1
ohm (adjustable)
Common Mode Rejection Range:
± 11 VDC maximum
Common Mode Rejection Ratio:
70 dB
Display, Control, Status, I/O
Front Panel
LED Displays indicate:
Run, Ready, Standby, Stop, and Fault
conditions in the output stage
LCD Display:
Lists type of fault condition and gives
suggested corrective action
Soft Touch Switches for:
Run (Enable), Stop, Reset
User Configurable:
LCD display can be configured for up to four simultaneous displays
reporting one, two or all four of the following: Voltage Peak,
Voltage RMS, Current Peak, and Current RMS
Back Panel
Power Connection:
NEMA-style locking receptacle; matching AC connector also
included
Signal Output:
4-position terminal barrier block
Signal Input:
User-selectable Unbalanced BNC or Balanced Barrier Strip
Interlock Connector:
25-pin D-sub connector used for amplifier control and status
applications; also used in multi-amplifier applications