Atec EMCO-2090 - Manual (Page 4)

Information presented is subject to change as product enhancements are made. Contact ETS Sales Department for current specifications. Information presented is subject to change as product enhancements are made. Contact ETS Sales Department for current specifications. Information presented is subject to change as product enhancements are made. Contact ETS Sales Department for current specifications. Information presented is subject to change as product enhancements are made. Contact ETS Sales Department for current specifications. Information presented is subject to change as product enhancements are made. Contact ETS Sales Department for current specifications. 2/00 - 2k S © 2000 ETS-EMCO REV B 2/00 - 2k S © 2000 ETS-EMCO REV B 2/00 - 2k S © 2000 ETS-EMCO REV B 2/00 - 2k S © 2000 ETS-EMCO REV B 2/00 - 2k S © 2000 ETS-EMCO REV B
USA:
Tel +1.512.835.4684
Fax +1.512.835.4729
FINLAND:
Tel +358.2.8383.300
Fax +358.2.8651.233
ONLINE:
[email protected]
http://www.emctest.com
Positioning Controller
Upgrade Kits
Now your older ETS-EMCO tower and
turntable can operate with all of the new
command features available with our
Model 2090 Positioning Controller. All
you need is our Retrofit-Kit and a Model
2090 Controller to replace your existing
EMCO Model 1050, 1060, 1060C or 1090
Controller. You'll be able to control two
devices (tower or turntable) and four
auxiliary devices at once, plus access the
SEEK, SCAN, target overrun, and
multiple limit functions. For a thorough
description of all Model 2090 features
and functions please turn to page one.
Note: Bore Sight functions are only
available with Model 2071 towers.
To install the Retrofit-Kit, the included
interface box is placed in line between
the tower/ turntable motor box and
controller. Existing cables are used
between the tower/turntable motor box
and the Retrofit-Kit's interface box. Fiber
optic cables are connected between the
interface box and the new Model 2090
Positioning Controller.
Retrofit-Kit to replace
Model 1050 or 1060 Controllers
PN # 105637
Retrofit-Kit to replace
Model 1090 Controller
PN # 105797
Retrofit-Kit for non-EMCO
towers/turntables
CALL FOR QUOTE
All kits consist of an interface box with
power cord and a 10 meter fiber optic
cable.
Specifications
4 44 44
Options
l Custom length fiber optic cable
l Custom length wire cable
l Hand Control Unit
(SELECTABLE)
Retrofit-Kit 35.6 cm 30.5 cm 16.5 cm 11.4 kg 115/230 50/60
for 1050, 1060 14.0 in 12.0 in 6.5 in 25.2 lb
MODEL PHYSICAL ELECTRICAL
WIDTH DEPTH HEIGHT WEIGHT VOLTAGE Hz
Positioning Controller
Test Site Hardware
Model 2090
Power to Model 1090
Motor Box
Optional
Hand
Control
Unit
Existing (pre Model 2090)
Tower / Turntable
Motor Box
Existing Cables
(one cable on 1090 kit)
New
Interface Box
New
Fiber Optic Cable
Model 2090 Controller