Atec All-Test-IV-Pro - Manual (Page 3)

Features
Easy To Use
An automatic test mode is used for most tests. On screen
prompts walk you through the test. In just a few minutes,
anyone can learn to use it!
On The Spot Diagnosis For Troubleshooting
ALL-TEST IV PRO ™ results are immediately displayed for field
evaluation. Our quick reference guide helps you make the call on
the spot. Answer the mechanical/electrical question immediately,
rule the motor “in” or “out”.
Data Collector With Companion Software
For PdM
The ALL-TEST IV PRO ™ has enough memory to store 500 tests
(more than a day’s work). Upload test results to your computer,
our software provides expert diagnosis, trending, and a wide
variety of printed or on screen reports.
Convenient–Test From The Motor
Control Center
Most tests on installed motors are done from the MCC, you can
test through over 1000 feet of cable. Even hard to reach motors
(overhead cranes, submersible pumps, etc) can be tested quickly
and easily. In many cases you do not even need to disconnect
from the drive output terminals! No need to test at the motor
terminals unless a fault is indicated.
Safe For Operators And Equipment
All tests are performed on de-energized circuits. Measurement
technology is low voltage and current, and completely non-
destructive. Regular and repeated testing will not affect the
life of the windings.
Quickly Evaluates The Entire Motor Circuit
A single 2 minute test evaluates the windings, cabling, and
connections. Additional tests let you evaluate the rotor, and
capacitors, and cabling to pinpoint the fault.
Sensitive
Detects motor faults at their earliest stages. Even detects
conditions such as deteriorating or contaminated insulation.
Light Weight And Hand Held
The instrument weighs under 2 lbs, is battery powered and hand-
held. No need to take a cart when you test a motor. And it can
test virtually any size motor.
Tests All Kinds Of Motors And Coil Based
Devices
• All types of motors: induction, synchronous, DC, brushless
DC, servo, wound rotor, even single phase motors.
• All Components: induction windings and rotors, DC
shunt and field windings, armatures, Field and rotor coils
in synchronous motors.
• Transformers: Single and 3-phase, pole and pad mounted.
ALL-TEST IV PRO
™
Testing the electrical health of a motor/pump combination
lets you make a better repair/replace decision.
A 2-minute test from the MCC evaluates the windings, cabling,
and connections through even hundreds of feet of cable.