Site master options – Atec Anritsu-S332D-31D User Manual
Page 8
Channel Scanner (Option 27, S332D)
The Channel Scanner option measures the power of multiple transmitted signals,
and is very useful for measuring the channel power of AMPS, iDEN, GSM, and
TDMA networks.
CW Signal (Option 28, S332D)
Provides a CW signal from –6 dBm to –80 dBm in 1 dB step from 25 MHz to 2 GHz.
The attenuator connected to the RF port can be varied from 0 to 90 dB in 1 dB steps
and the splitter divides the signal into two signals: One is fed into the device under test
and one is fed into the Spectrum Analyzer Receiver port. The display shows the output
power and the frequency.
Power Meter (Option 29, S331D and S332D)
The power meter tool performs accurate transmitter power meter measurements
from 4.5 MHz to 3 GHz reducing coverage holes and interference. The Spectrum
Analyzer is used to measure the channel power and results can be displayed in
dBm or Watts. No external detector is required.
GPS Receiver (Option 31, S331D and S332D)
Built-in GPS provides location information (latitude, longitude, and altitude) and Universal
Time (UT) information. Site Master can stamp each trace with location information to check
if the measurements are taken at the right location. Site Master stores the GPS location
information until the unit is turned off. This stored location information can be used
to stamp traces taken indoors at the same cell site location. The GPS option is
offered with a magnet mount antenna with a 15-foot (~ 5m) cable to mount on
the car or other useful surface.
T1/E1 Analyzer (Option 50, S331D)
Site Master built-in T1/E1 Analyzer performs T1/E1 functional tests, simplifying
the task of determining if the source of the problem is on the wireline or the
wireless side. Site Master can display the T1/E1 data in histogram form and collect
the data for up to two days. Site Master can also measure the voltage (Vpp) of the
signal and it can also be displayed as dBdsx.
8
Site Master Options