Alpha Technologies Battery Racks - Manual (Page 14)

14
3.6 Feed the fixing rod through the holes in the hold-down angle bar. Insert washer and
install wing nut until hand tight as shown in figure 3.6.A. Fixing rods are installed in
opposite directions on every-other battery spacing (see figure 3.6.B & 3.6.C)
3.7 Installation is now complete for Seismic battery racks.
Note:
Manufacturer shall not be liable for, and user shall indemnify and save manufacturer harmless from any and
all claims and liabilities arising out of the use, maintenance, transportation, or installation of any equipment
warranted hereunder. The foregoing limited warranty is in lieu of all warranties express or implied, including
any warranty of merchantability or fitness for a particular purpose. Manufacturer shall not have any liability for
any special, incidental, indirect, or consequential damages.
This limited warranty applies only to the original purchaser (user) of the equipment, is non-transferable, and is
governed by and construed under the Washington State laws.
Wingnut
Fixing Rod
Hold-down angle bar
NOTE: 25mm side
Washer
Figure 3.6.A
Figure 3.6.B Figure 3.6.C