Alera Lighting AL 2-Light - Manual (Page 4)

Page 4/4 Rev. 01/14/14 RECESSED / AL 2-LIGHT TID
AL 2-LIGHT
Technical Installation Data
© 2014 Alera Lighting, a division of Hubbell Lighting, Inc. Specifications subject to change without notice.
701 Millennium Blvd. Greenville, SC 29607 / Tel 864.678.1000 / Website www.aleralighting.com
HARD CEILING APPLICATIONS
The AL system is designed primarily for suspended acoustical ceilings. Fixture trim will not support drywall. Additional drywall support must be
provided adjacent to fixture by ceiling installer.
The sketch to the right shows a method of installing the AL in a drywall ceiling. Note the ceiling must be installed
after the AL housings. Also,
the access holes to the plenum through the fixture must be cut by the contractor.
Reflector
12"
"AL" Housing (Chassis)
Electrical Unit
Wall Rail
Wall Plate
10 3/8"
Wall Line
8 1/2"
9 15/32"
Parabolic Louver
Non-supporting
fixture trim
Access to ceiling for
wiring and J-Box
inspection must be cut
in housing by installing
contractor
Install drywall into fixture
trim and secure other end to
building structure
Ceiling Construction (by others)
10"