Alera Lighting AL1066 - A+CLASS Quick Start Guide User Manual
Alera Lighting Lighting
![background image](/manuals/317223/1/background.png)
Shown with
General / A/V, and
Study Time
Optional Dimming Functions available up to 4 rows. Plug into orange port number which corresponds to dimming
lighting row. Dimming functions require 0-10V dimming ballasts. PLK shown below. Light fixture styles may vary.
Whiteboard Switch
Master On/Off Control
Main Power Feed In
Row On/Off Control
• One connection required for each participating row
• Requires 0-10V dimming ballast
• 1-4 zones Daylight Harvesting zones available
• One connection required for each row with Teacher A/V or
GEN Dimming
• Requires 0-10V dimming ballast
• Any row which utilizes both Daylight Dimming and Teacher
A/V or GEN Dimming
• One connection required for each participating row
• Requires 0-10V dimming ballast
Daylight Sensor
Row 1 General / A/V Light Fixtures
Row 2 General / A/V Light Fixtures
1 Whiteboard Connection
Occupancy Sensor
Daylight Dimming
Teacher Dimming
Combined Daylight Dimming and Teacher Dimming
If separate from
Teacher Station
Plug into any Green port
Plug into any White port
Teacher Station
Accommodates up to 4 rows (2 rows shown). Lighting fixture styles may vary from those shown below.
For recessed General and A/V lighting options contact factory.
Low VoLtage ConneCtions
CLassroom ControL moduLe (CCm)
Line VoLtage output ConneCtions
Parawash (PW) Recessed Option
Microlyne Aysmmetric (MA) Suspended
A+CLASS™ SD Card ships installed.
Quick-To-Install™ (QTI) Connector
Connect male QTI connector (A) to female
orange dimming cable QTI connector (B).
Return orange cable with CAT5 connector
to CCM. Row Jump connector (C) only,
not required in continuous row lighting
applications.
Low voltage dimming cable with QTI (A)
and CAT5 connectors (B or C) provided.
Note: Place dimming low voltage CAT5
connector into corresponding row port.
Low voltage feed cord with two QTI
connectors on one end (provided). QTI to
orange CAT5 at right (A), QTI to connect
virtual “row” (B); used for recessed or
singles only. Attach low voltage wires as
per wiring diagram provided with lighting
fixture.