Alera Lighting AL 2-Light - Manual (Page 3)

Page 3/4 Rev. 01/14/14 RECESSED / AL 2-LIGHT TID
AL 2-LIGHT
Technical Installation Data
© 2014 Alera Lighting, a division of Hubbell Lighting, Inc. Specifications subject to change without notice.
701 Millennium Blvd. Greenville, SC 29607 / Tel 864.678.1000 / Website www.aleralighting.com
Special Notes for Patterns with Corners
1. Housings: When installing patterns with corners, install corner housings first after the installation of all wall rails (and wall plates). Then
proceed with each straight run per above.
2.
Electrical: (a) AL row lengths are pre-calculated to provide ample light in corners. Be sure electrical units extend fully into corners before
field cutting. (b) For corners requiring a continuous circuit around corner, a pre-cut flex conduit connector kit is provided
3. Diffusers: Plastic for corners has pre-cut 45 angles. Install angled corner pieces first and then straight-cut final remaining piece to fit.
Inside Corner Reflector Service Cover Power
Access Only
Inside Corner Louver
Inside Corner Reflector
Adjustable
Electrical Unit
Adjustable
Housing
Power Feed
Inside Corner
Housing
Trim Connector/
Aligner
21" Housing
90" Housing
Adjustable
Housing
Trim Rail, Cut
to length
Adjustable Electrical Unit
Electrical Unit
Electrical
Unit
Outside Corner Flex
Outside Corner Reflectors (2)
Outside Corner Louver
Note: Wall Rail and Wall Plate not shown (see below)
21" Housing
Outside Corner
Housing
Electrical
Unit
Inside Corner Flex
Work in this direction
Pattern with Corners (View shown from wall side)
INSTALLATION DATA