Alera Lighting AL 2-Light - Manual

Page 1/4 Rev. 01/14/14 RECESSED / AL 2-LIGHT TID
AL 2-LIGHT
Technical Installation Data
© 2014 Alera Lighting, a division of Hubbell Lighting, Inc. Specifications subject to change without notice.
701 Millennium Blvd. Greenville, SC 29607 / Tel 864.678.1000 / Website www.aleralighting.com
General
1. Fasteners not provided for wall rail or wall plates.
2. All fasteners provided for housing, endplates, connector/aligners and electrical unit connections.
3. Pieces requiring a field cut:
Wall Rail (steel), Wall Plate (steel), Trim Rail (aluminum), Wireway Cover (aluminum) and Diffusers (plastic,
steel, or aluminum)
Housing (CAUTION: For hard ceiling applications, see page 4.)
1. Install wall rails (see next page), fasteners not provided.
2. Install wall plates if required. Fasteners not provided.
3. Starting from right end of row (facing wall) install endplate on first (shortest) housing with screws and nuts provided.
4. Install first (shortest) housing and work to left installing progressively longer housings.
5. Top lip of housings tip into upper hook form of wall rail. Secure housing firmly in place by flattening wall rail bend tab over housing lip.
6. Connect hanging wires loosely.
7. Install each successive housing (shortest to longest) in similar manner, connecting housings with screws and nuts provided and then hang
loosely on hanging wires.
8. Also install
trim connector/aligners at each joint as row installation progresses.
9. Install endplate on adjustable housing into last "fixed length" housing and hang entire assembly as a unit. Adjustable housing is then pulled
out to required dimension.
10. Square-cut
trim rail for adjustable housing to required length; drill four (4) each 7 /
32
" holes using template provided and install with sheet
metal screws.
11. Level entire row on hanging wires.
Sample: AL-2T8-P-R-LD-EPU-15.00 consists of:
(3) 92745 Wall Rails
(3) 92746 Wall Plates
(1) 97561-00 90" Housing
(1) 97561-03 33" Housing
(1) 97561-04 21" Housing
(1) 97559-00 ADJ Housing
(4) 114084 Reflector (2) AL4 2T8 EPU
(1) AL3 2T8 EPU
(1) AL3 2T8 EPU ADJ
(4) 107945-04 Parabolic Louvers
(1) 116612 Electrical End Assembly
(2) 97416-00 End Row End Plates
INSTALLATION DATA
Power Feed
Straight Run (View shown from wall side)
33" Housing
Plug-In Connector
Endplate
Service Cover
Power Access Only
Parabolic Louver
Wall Rail
Wall Plate
(where required)
Reflector
(where required)
Drill (4) holes
(template provided)
Connector Plate
AL4-2T8-EPU
4' Electrical Unit
AL3-2T8-EPU
3' Electrical Unit
Electrical End
Assembly
AL4-2T8-EPU
4' Electrical Unit
Trim Rail,
cut to length
Trim Connector/
Aligner
AL3-2T8-EPU-ADJ
3' Adjustable Electrical Unit
Wireway cover
(cut to length)
Cut
Electrical End
Assembly
Endplate
Adjustment
Adjustment Housing
90" Housing
21" Housing
Work in this direction
Hanging
Wires