ABUS RM40Li VdS Smoke Detector - Manual (Page 30)

– 30 –
• Alternatively, you can use the RM test spray available from ABUS to test the wireless
smoke detector. If the RM test spray enters the detection chamber, an alarm
should sound, so that you can test whether the wireless smoke detector is
working properly.
ʥ $פHU HDFK WHDFKLQJ SURFHVV DQG WHVW DODUP WKH GHYLFHV UHTXLUH D ъщ PLQXWH
FDOLEUDWLRQ SHULRG LQ RUGHU WR H[FKDQJH HQRXJK GDWD SDFNHWV 3OHDVH GR QRW
initiate a test alarm during this time.
Networking the wireless smoke detectors
• Please note: do not network another model of wireless smoke detector
with this one. This may lead to improper functioning and it cannot be
guaranteed that the device will operate problem-free.
• If the test mode on one detector in a network is activated, all other
networked detectors will produce a signal too.
• If one of the detectors in the network detects an alarm, all other
detectors in the network will raise the alarm.
• If the battery in one detector is low, this will be indicated directly by the
DלHFWHG GHWHFWRU ,Q DGGLWLRQ WKLV ZLOO DOVR EH LQGLFDWHG E\ DOO QHWZRUNHG
GHWHFWRUV HYHU\ э KRXUV E\ ы EHHSV DQG D ףDVKLQJ /('
Networking the detectors (recommended before installation)
You will require at least two RM40 Li wireless smoke detectors to be able to create
D ZLUHOHVV GHWHFWRU QHWZRUN $ PD[LPXP RI ьы GHWHFWRUV FDQ EH QHWZRUNHG
Due to the network connection, the distance between individual detectors must
EH D PD[LPXP RI ьщ P 7KH ZLUHOHVV UDQJH FDQ EH QHJDWLYHO\ LQףXHQFHG E\ WKH
structural surroundings. The RM40Li detectors can be cascaded, meaning that the
detectors are not connected in one direction only, so the alarm signal can be
WUDQVPLWWHG IURP WKH נUVW WR WKH ODVW LQ D FKDLQ
Putting into operation