ABUS SG1810 Profiline sounder - Manual (Page 12)

12
3. Main features
• Robust, weatherproof external sounder
• High-volume 106 dB sounder
• LED strobe technology with a long service life and
low power consumption
• Turnable polycarbonate housing
• Internal metal casing to prevent tampering
• Adjustable sounder duration and signal
• Input protected to over-voltage and polarity reversal
• Inputs for positive or negative trigger signal
• Trouble output and status LED
• Backup power supply from battery (12 V/2.1 Ah)
• Auto-recharging battery circuit with automatic disconnection against battery
deep discharge.
• Tamper protection through wall and cover contact
4. Scope of delivery
• 1 x compact alarm
• 1 x installation instructions
• 1 x drill template
• 4 x screws (DIN 7981; 3.9 mm x 32 mm)
5. Installation
1. Open the front cover by unscrewing and removing the fixing screw on the
bottom of the compact alarm.
2. Use the template to mark the drill holes on the surface on which you want
to mount the alarm.
3. Drill the holes and insert wallplugs.
4. Pull the connection cables through the backplate of the sounder.
5. Screw the backplate of the sounder firmly to the mounting surface.
6. Remove the internal metal casing by unscrewing and removing the lower
screw.
7. Wire up the compact alarm and set the jumpers and dip-switches
according to the required behaviour (see next section, “6. Putting into
operation”).
8. Connect the battery (12 V/2.1 Ah) for the backup power supply.
9. Replace the internal metal casing and close it with the screw, and do the
same for the front cover.