AAEON IMBM-Q67A - Manual (Page 29)

2-21 Chapter 2: Motherboard information
12. ASM 1061 Serial ATA 6Gb/s connector (7-pin SATA6G_1 [gray])
This connector connects to Serial ATA 6Gb/s hard disk drives and optical
drives via Serial ATA 6Gb/s signal cables.
NOTES:
• This connector is set to [IDE Mode] by default. In IDE mode, you can
connect Serial ATA bootable hard disk drives installed only with Windows ®
XP / Windows ® 7, or Serial ATA data hard disk drives to this connector.
• ATAPI devices are not supported on this connector.
• You must install Windows
® XP Service Pack 3 or later version before using
Serial ATA hard disk drives.
• When using hot-plug and NCQ, set the ASM1061 Storage Controller
item in the BIOS to [AHCI Mode]. See section 3.4.10 Onboard Devices
Configuration for details.
SATA6G_1
GND RSATA_RXP1 RSATA_RXN1 GND RSATA_TXN1 RSATA_TXP1 GND
IMBM-Q67A ASM 1061 SATA 6.0Gb/s connector
IMBM-Q67A