AAEON IMBM-Q67A - Manual (Page 27)

2-19 Chapter 2: Motherboard information
8. Intel ® Q67 Serial ATA 3Gb/s connectors (7-pin SATA3G_1~4 [blue])
These connectors connect to Serial ATA 3Gb/s hard disk drives and optical
drives via Serial ATA 3Gb/s signal cables.
NOTES:
• These connectors are set to [IDE Mode] by default. In IDE mode, you can
connect Serial ATA boot/data hard disk drives to these connectors. If you
intend to create a Serial ATA RAID set using these connectors, set the
SATA Mode item in the BIOS to [RAID Mode]. See section 3.4.5 SATA
Configuration for details.
• You must install Windows ® XP Service Pack 3 or later version before using
Serial ATA hard disk drives. The Serial ATA RAID feature (RAID 0, 1, 5, and
10) is available only if you are using Windows ® XP SP3 or later version.
• When using hot-plug and NCQ, set the SATA Mode item in the BIOS to
[AHCI Mode]. See section 3.4.5 SATA Configuration for details.
9. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
SATA3G_3
GND RSATA_RXP3 RSATA_RXN3 GND RSATA_TXN3 RSATA_TXP3 GND
SATA3G_4
GND RSATA_RXP4 RSATA_RXN4 GND RSATA_TXN4 RSATA_TXP4 GND
SATA3G_1
GND RSATA_RXP1 RSATA_RXN1 GND RSATA_TXN1 RSATA_TXP1 GND
SATA3G_2
GND RSATA_RXP2 RSATA_RXN2 GND RSATA_TXN2 RSATA_TXP2 GND
IMBM-Q67A Intel ® SATA 3.0Gb/s connectors
IMBM-Q67A
IMBM-Q67A
IMBM-Q67A Chassis intrusion connector
GND
Chassis Signal
+5VSB_MB
CHASSIS