Cla-Val 136-01/636-01 Technical Manual - Manual (Page 24)

CLA-VAL
Copyright Cla-Val 2008 Printed in USA Specifications subject to change without notice.
P.O. Box 1325 • Newport Beach, CA 92659-0325 • Phone: 949-722-4800 • Fax: 949-548-5441 • E-mail: [email protected] • Website cla-val.com
©
Torque Chart
Part Name
terminal block screws
socket head screw
center screw
Torque Value in inch-Pounds
10 ± 2
15 - 20
5 ± 1
Torque Value in Newton-Meters
1,1 ± 0,2
1,7 - 2,3
0,6 ± 0,1
Open Frame Solenoid
with 1/4" Spade Terminals
tapped hole for
#10-32 grounding screw
(not included)
See
torque chart
above
Open-Frame Solenoid
with Screw Terminals.
Socket head screw is
used for grounding.
Screw terminal
adapter
terminal
block
screw
socket head
grounding screw
(5/32" hex key wrench)
Open-Frame Solenoid
with DIN Terminals.
gasket
DIN terminal
adapter
socket head screw
(5/32" hex key wrench)
Junction box Solenoid
with 1/4" Spade Terminals
or Screw Terminals
screw terminal block
(see note)
junction box gasket
junction box with
1/2" conduit connection
and grounding terminal
socket head screw
(5/32" hex key wrench)
cover screw
cover
cover gasket
grounding screw
and cup washer
See
torque chart
above
gasket
DIN terminal
adapter
connector
gasket
gland nut
gland gasket
washer
center screw
Open-Frame Solenoid
with DIN Terminal
Plug Connector
Note:
Junction box with screw terminals
shown. With screw terminal
block removed, remaining parts
comprise the junction box for
spade terminal construction.
See
torque chart
above
socket head screw
(5/32" hex key wrench)
DIN connector
terminal block
(see note 2)
connector cover
(see note 1)
Notes:
1. Connector cover may be
rotated in 90˚ increments from
position shown for alternate
postion of cable entry.
2. Refer to markings on DIN
connector for proper
electrical connections.
Indicates that these parts are included
in DIN plug connector Kit No. K236-034
*
*
*
*
*
*
*
Figure 4. Open - frame solenoids
Figure 5. Open - frame solenoids
N-V6583 (R-1/08)