Extron Electronics SW2 RGBHVcc User Guide - Manual (Page 9)

SW2 VGAcc and SW2 RGBHVcc • Installation SW2 VGAcc and SW2 RGBHVcc • Installation
Installation
Through-desk mounting
Both SW2 models can be mounted through a table or podium,
using optional through-desk mounting brackets (Extron part
#70-077-02).
1 . Attach the mounting brackets to the switcher with the
screws provided (figure 2-3).
2 . Cut the proper sized hole in the mounting surface.
3 . Hold the switcher with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4 . Drill 3/32” (2 mm) diameter pilot holes, 1/4” (6.3 mm) deep
in the mounting surface at the marked screw locations.
5 . Insert four #8 wood screws through the bracket and into the
four pilot holes. Tighten all four screws to secure the
switcher in place.
Figure 2-3 — Through-desk mounting
Rear Panel Features and Connections
All connectors are on the rear panel. Figure 2-4 shows the rear
panel of the SW2 VGAcc switcher, and figure 2-5 shows the rear
panel of the SW2 RGBHVcc.
Power connection
1 AC power connector — Plug a standard IEC power cord
into this connector to connect the switcher to a 100 to 240
VAC, 50/60 Hz power source.
Figure 2-4 — Rear panel – SW2 VGAcc switcher
Figure 2-5 — Rear panel – SW2 RGBHVcc switcher
Signal input and output connections
2 Computer input connectors :
SW2 VGAcc — Connect your computer input (VGA,
SVGA, XGA, SXGA, UXGA, RGBHV, RGBS, RGsB or
RsGsBs computer video) to the 15-pin HD female
connectors.
SW2 RGBHVcc — Connect your computer input (RGBHV,
RGBS, RGsB, RsGsBs, component video, S-video (Y/C),
and composite video) to the BNC female connectors.
2-4 2-5
50/60 Hz
100-240V 0.2A
SW2 RGBHVcc
OUTPUT
R G
H V
B
INPUTS
R
R
2
1
G
G
B
B
H
H
V
V
1 2
CONTACT
TALLY
OUT
1 2
3 2
4 1
INPUTS OUTPUT
1 2
50/60 Hz
100-240V 0.2A
1 2 1 2 SW2 VGAcc
CONTACT TALLY OUT
3 2
4 1