Extron Electronics SW2 RGBHVcc User Guide - Manual (Page 10)

SW2 VGAcc and SW2 RGBHVcc • Installation
Installation, cont’d
SW2 VGAcc and SW2 RBGHVcc
3
Chapter Three
Operation
Front Panel Controls and Indicators
Troubleshooting
2-6
3 Output connector :
G
RGBHV
RGBS
RGsB,
RsGsBs,
Component
B H V
R G B V
R
G B H V
G
S-Video
B R H V
G
Composite
B
R
H V
R
H
Figure 2-6 — BNC output connector set up
SW2 VGAcc — Connect the output device to the 15-pin HD
female connector.
SW2 RGBHVcc — Connect the output device to the 5 BNC
female connector.
Remote connection
4 Remote contact closure/tally out connector — Connect a
control module to this 3.5 mm 5-pole captive screw
connector to allow remote switching through contact
closure, or activity feedback through tally out.
PIN
Tally
Out
Contact
Closure
Function
1 — In #1 Input #1 (contact)
Input #2 (contact)
2 —
3
4
—
In #2
5
Gnd Gnd Ground
1 2 1 2
CONTACT
TALLY
OUT
In #1
In #2 Input #1 (tally)
Input #2 (tally)
—
(1) (2) (3) (4) (5)
Figure 2-7 — Contact closure and tally out connector
pinout