Extron Electronics RCP 2000 - Manual (Page 20)

RCP 2000 • Remote Control
Remote Control, cont’d
RCP 2000 Remote Control Panel
A
Appendix
Specifications, Parts, and
Accessories
Specifications
Part Numbers
4-10
Figure 4-7— ISS Control screen
Using network switcher control
To use network switcher control, follow these steps:
1 . Set the level of control desired: video/audio, video only, or
audio only.
2 . Select the Program (output) that you want to switch.
3 . Select the Preview (input) that you want to switch to.
4 . Set the parameters of the switch (for example, Dissolve
Speed or RGB Delay), and click the appropriate button to
execute the switch (e.g., Cut, Dissolve, etc.).
- OR-
Click the button for the desired effect (for example,
Black/Mute, Freeze, Test Pattern, or Blue Screen Mode) for
the output.
To compare Program (output) and Preview (input) scan
rates, click View Program (or Preview) Scan Rate.
If you require a test pattern on either the Program or the
Preview, select the desired test pattern from the drop-
down menu; and select either the Program or the
Preview check box in the Test Pattern section of the
screen.
For a more complete description of seamless switching and the
options available for each switcher, refer to the user’s manual
for your specific switcher.