Cable the switcher – Extron Electronics USFM 100 Installation imp User Manual
Page 5
5
Signal Cable Access
Cutout Option
2400
V700
Raceway Option
Conduit Option
Figure 5.
Cabling Run Options
If running cable behind the walls:
Run all the cables from all the locations to the USFM 100 and through the access hole (cut in step 1d).
Proceed to step 4.
If using a surface raceway or conduit:
a.
Turn over the left or right cover as needed, and from the inside, cut the most suitable marked raceway or
conduit knockout for the cable to enter the USFM 100. Remove the knockout.
b.
Run the raceway or conduit from all locations to the marked entrance and attach to the baseplate.
c.
Run the cables through the raceway or conduit to the USFM 100.
4. Cable the Switcher
Connect the cables from the PoleVault wallplates, control device (MediaLink
®
Controller), speakers, and optional
accessories (VoiceLift, Page Sensor Kit) to the rear ports of the switcher. See the PVS 305SA Setup Guide for
connection details.
NOTE: If using a device other than a PVS 305SA (for example, PVS 204SA Plus), refer to the specific device guide
for details.
Tab
- AVTrac Corner Cut Solution (2 pages)
- AVTrac Demonstration Kit (2 pages)
- AVTRac End Ramp and Cable Pass-Through Kits (1 page)
- AVTrac Extension Kit (15 pages)
- 1U and 2U Rack Plate (1 page)
- Under-Desk Mounting Bracket (1 page)
- AAP Wiring Guide 68-1054-01 (1 page)
- AAP Wiring Guide 68-1052-01 (1 page)
- AAP Wiring Guide (XLR connectors) (1 page)
- AAP 314 (1 page)
- AAP 301 (1 page)
- AAP Wiring Guide 68-1055-01 (1 page)
- AAP Wiring Guide 68-1058-01 (1 page)
- AAP Wiring Guide 68-1059-01 (1 page)
- AAP-MAAP Rev. A (1 page)
- AAP-MAAP Rev. D (1 page)
- MD Floor Box AAP Bracket Kit AAP 100 MD (1 page)
- AC 100 Power Module Series (1 page)
- AAP 103 Extron Ackerman AKM UK Faceplate Kit (1 page)
- ACMP 100 (2 pages)
- Active Audio AAP (1 page)
- AKM UK Series (4 pages)
- Audio AAP Wiring Guide (1 page)
- Audio Connector Rev. A (2 pages)
- Audio Connector Rev. G (1 page)
- AVTrac Extra Channel Kit (2 pages)
- AVTrac Raceway Transition (2 pages)
- AVTrac Retrofit Transition Adapter (2 pages)
- AVTrac Trim Ring-Rough-in Adapter (2 pages)
- AVTrac Above Floor (1 page)
- BB 1 (2 pages)
- BB 1000M (2 pages)
- BB 700M (2 pages)
- BB 710M (2 pages)
- Blank Rack Panel (1 page)
- BNC to 15-Pin HD (1 page)
- BNC-5 RC Termination (1 page)
- Cable Cubby 1200 (6 pages)
- Cable Cubby 200 (18 pages)
- Cable Cubby 300C (27 pages)
- Cable Cubby 500 (6 pages)
- Flexible Conduit Kit (2 pages)
- Cable Cubby Lid and Trim Ring Replacement Kit (for 300C, 300S, 600, 800) (1 page)
- Cable Cubby Setup Guide (4 pages)
- Cable Cubby Single Space AAP Bracket Kit (1 page)