Extron Electronics MLC 206 Backlight Replacement Guide - Manual

1 MLC 206 • Backlight Replacement Guide
DVCAM
Preset 1
Menu
Menu
Laptop 2
DVD
DVCAM
DVD
Preset 1
Menu
Laptop 2
Laptop 1
Extr
on
Medi aLi nk C on trol ler ML C 20 6
DISPLAY POWER
VOLUME
MAX/
MIN
Extr
on
Medi aLi nk C on trol ler ML C 20
6
DISPLAY
POWER
VOLUME
MAX/
MIN
Remove four screws.
Remove four screws.
Faceplate
Plastic Window
Plastic Label Frame
Labels
Electroluminescent
Backlight Circuit Board
LED Backlight
Circuit Board
Foam
Label Holder
Plastic Window
Faceplate
MLC 206 with
Electroluminescent
Backlight Circuit Board
(part #20-440-01)
MLC 206 with
LED Backlight Circuit Board
(part #20-497-01)
Replacement kits are available from Extron for the MLC’s backlights. The MLC 206
is shown in the examples, but the instructions apply to all models. Follow the
steps below to replace the backlight.
1. Remove the MLC from the furniture or wall (if it was previously installed) by
removing the four screws marked
1 in the picture below.
2. Use a small Philips screwdriver to remove the four faceplate attachment
screws marked
2 in the picture at
right, and keep them for later use.
Do not remove these screws (
2
)
while the MLC is installed in a
wall or furniture, or the controller
may fall down into the wall/
furniture or wall box.
3. Lift the faceplate off the MLC.
4. Lift off the transparent,
protective, plastic
window that
covers the
labels.
Extron
MediaLink Controller
MLC 206
DISPLAY POWER
VOLUME
MAX/
MIN
VCR DVD Laptop
2
2
2
2
1 1
1 1
MLC 206 Backlight Replacement Guide
68-728-01 Rev. B
Printed in the USA
12 02