Extron Electronics AAP 100 MD - Manual (Page 2)

MD Floor Box AAP Kit • Installation
Installation
2
3. Remove Screws
4. Slide
Introduction
This guide covers installation of the Extron MD Floor Box AAP
Bracket Kit in a Matsushita Denko (MD) floor box. It shows
removal of the old bracket and installation of the new
bracket/AAP unit.
Installation
C Installation and service must be performed by
authorized personnel only.
1 . Turn off and disconnect power from all
equipment connected to the floor box.
2. Remove all cables connected
to the portion of the
floor box accessible
when the lid is open (if
applicable).
3. Open the lid and remove
the two screws securing
the lid to the floor box.
4. Remove the lid from
the floor box by
sliding the lid
toward the hinge to
disengage it from the
box, then put the lid aside.
N If there is no adapter plate or blank plate installed, skip to
step 8.
5. Remove the two screws securing the old adapter plate
bracket to the box.
5. Remove Screws
6. Slide the adapter plate bracket to the center of the box
and disconnect the cables attached to the back side of the
adapter plate.
7. Remove the old adapter plate bracket and adapter plate
unit from the floor box.