Extron Electronics MMX 42_62 Series User Guide - Manual (Page 25)

MMX 42/62 Series Matrix Switchers • Remote Control
Remote Control, cont’d
4-18
MMX 42/62 Series Matrix Switchers
A
Appendix A
Reference Information
Specifications
Part.Numbers
Communication menu
Connect (shown unavailable) — Available
only when no switcher is connected
to the program, this selection opens
the Communications Setup window, from where you can
connect to a switcher. This selection is also available via
the tool bar's Connect button ( ).
Disconnect — Available only when a switcher is connected to the
program, this selection disconnects the switcher from the
program. This selection is also available via the tool bar's
Disconnect button ( ).
Configure menu
Refresh Window Layout — Restores
the Universal Switchers
Control Program to its
default display layout (Unit
Info field displayed and
Communications Log turned
on.
Refesh Signal Status — Issues the SIS "I" command and displays
the results (all video and audio ties and all video and audio
mutes) in the window. This selection is also available via
the tool bar's Refresh button ( ).
Front Panel Lock — Locks or unlocks all Input buttons and the
Configuration button. See "Front panel security lockout
(Executive mode)". This selection is also available via the
tool bar's Lock button ( ).
Firmware Loader ... — Calls the Extron Firmware Loader utility
(if installed on the PC) to replace the switcher's firmware.
See "Updating the firmware". This selection is also
available via the tool bar's Firmware Loader button ( ).
Unit Resets — Allows you to execute several switcher resets:
System, Audio Input Gain, Video Mute, and Audio Mute.
See the "Reset Commands" SIS commands for more information.
Using the help system
For information about program features, you can access the help
program in any of the following ways:
•
Click Start > Programs > Extron Electronics > Universal
Switcher
> Universal Switcher Control Help.
• From within the Windows-based switcher control
program, click on the Help entry on the task bar.
• From within the Windows-based switcher control
program, press the F1 key.