Extron Electronics IN2112R - Manual (Page 13)

11
©1999 - INLINE, INC. IN2112R OPERATION MANUAL - PRELIMINARY 08/31/00
DIPSWITCH SETTINGS
Most installations will not require any changes to the dipswitch settings, and the IN2112R will generally be
operated with the factory default settings. The Factory Default settings and specialized dipswitch settings
are indicated below. Please note that when the interface is held upright, the dipswitches are numbered from
10 to 1 as shown below.
Factory Default Settings:
Dipswitches ON: 1, 2, & 4
Signal Format: Red / Green / Blue / Horizontal and Vertical Sync
Horizontal Position Control: Enabled
H & V Sync Polarity: Negative, Negative
Serration Pulse Generator: Serration Pulses Enabled
Monitor Emulation Input 1: Auto Termination Enabled
Monitor Emulation Input 2: Auto Termination Enabled
Autoswitching: Disabled
The table below lists the functions of the 10 dipswitches:
Switch Function Setting
1 Horizontal Position Control
On Horizontal Position Enabled*
Off Horizontal Position Disabled
2
Output Sync Format Selection:
Select Sync on Green or Separate Sync On RGBS / RGBHV*
Off Sync on Green
3
Output Sync Format Selection:
Select RGBS or RGBHV On RGBS
Off RGBHV*
(Switch 2 must be On in order to get
RGBS or RGBHV Output Format)
4 RGBHV Output Polarity
On Negative Sync Polarities*
Off Mirror Input Polarities
5 Serration Pulse Generator
On Serration Pulses Disabled
Off Serration Pulses Enabled*
6 Input A Monitor Emulation - Pin 11
On Pin 11 Always Grounded
Off Pin 11 State Set by Auto Termination*
7 Input A Monitor Emulation - Pin 10
On Pin 10 Always Grounded
Off Pin 10 State Set by Auto Termination*
8 Input B Monitor Emulation - Pin 11
On Pin 11 Always Grounded
Off Pin 11 State Set by Auto Termination*
9 Input B Monitor Emulation - Pin 10
On Pin 10 Always Grounded
Off Pin 10 State Set by Auto Termination*
10 Input A/B Auto-Switch
On Auto-Switch Enabled
Off Auto-Switch Disabled*
*Factory Default Settings
1 10
ON
OFF