Extron Electronics IR 102 Kit - Manual (Page 8)

IR 102 Remote Control Kit • Installation and Operation
Installation and Operation, cont’d
1-6 IR 102 Remote Control Kit • Installation and Operation 1-7
Projector
Projector
Mounting
Bracket
Mounting
Bolt
Extron
IR 102 RX
Remote Receiver
Projector mounting the IR 102 Rx using the PMK 100
mini projector mounting kit (#70-217-01)
Mounting using the PMK 300 projector mounting kit
Alternatively, the IR 102 Rx remote receiver can be projector
mounted using the optional PMK 300 multi-product projector
mounting kit, part #70-374-01.
N Only VersaTools products and most IP Link products
can be mounted using the multi-product projector
mounting kit.
The PMK 300 multi-product projector mounting kit (#70-374-01)
mounts up to three quarter-rack width products to a projector
ceiling mount pole. The IR 102 Rx can be mounted above the
display device with the front panel facing either down or up.
The quarter rack width plate can also be used to mount the
IR 102's external desktop power supply.
Extron
PMK 300
Multi-product Projector Mount Kit
U-bolt
Front Mounting
Plate
Side Mounting
Plate
Extron
IR 102
Rx Remote Receiver
Power Supply
Countoured
Bracket
Base
Projector-mounting the IR 102 Rx using the PMK 300
projector mounting kit (#70-374-01)
Follow these steps to mount the IR 102 Rx receiver using the
PMK 300:
1. If necessary, remove the feet from the bottom of the IR 102.
2. Mount the IR 102 to one of the bracket’s three mounting
plates, using two of the supplied 4-40 x 3/16" screws in
opposite (diagonal) corners to secure the device to the
bracket. It can be vertically mounted facing either up or
down. See the illustration, above.
• On the side mounting plates, the IR 102 is typically
mounted on the outside of the bracket.
• On the front mounting plate, the device is typically
mounted on the inside of the bracket.
3. Using the two included tie wraps, strap the power supply
to one of the brackets.
4. Place the contoured bracket base against the projector
ceiling pole and opposite the back plate. The pole should
fi t snugly into the depression in the center of the contoured
base.