beautypg.com

Installing batteries in the remote control, Operation, Working with a control system – Extron Electronics IR 102 Kit User Manual

Page 12: Installation and operation, cont’d

background image

IR 102 Remote Control Kit • Installation and Operation

Installation and Operation, cont’d

1-14

IR 102 Remote Control Kit • Installation and Operation

1-15

Installing Batteries in the Remote Control

The IR 102 handheld remote control is shown below.

Universal Remote

INPUT/OUTPUT SELECTION

1

2

3

4

5

6

7

8

9

0

+10

ENTER

IR 102

IR 102 remote control

Install two AAA batteries in the remote as shown below. The
battery compartment is in the front, bottom side of the remote
control.

Installing batteries in the IR 102 remote control

Operation

To select an input using the IR 102 remote control, aim the
handheld unit at the IR detector and press the numeric button
for the desired input. For switchers with ten or more inputs,
press the +10 key to add ten to the input number selected. For
example, to select input 17, press the +10 key, then the 7 key.
The maximum operating range is 30 feet.

Working with a control system

IR 102 Rx

UNIVERSAL IR REMOTE RECEIVER

RS-232/

CONTACT

OUT

RS-232

Tx Rx

1 2

3

4

5

+5

+12V

6

CONTROL OUT

IR IN

CONTACT

MOD

DEMOD

POWER
12V
.5A MAX

RS-232

IN

SW6 VGA Ars

REMOTE

100-240V 0.2A

INPUTS

1

2

3

4

5

50-60Hz

OUTPUT

OUTPUT

L

R

SW6 VGA Ars

6

Univ

ersal Remote

INPUT/OUTPUT SELECTION

1234

5678

90

+

1

0

E

N

T

E

R

IR 102

REMOTE

IR 102 Rx Remote
Control Receiver

IR 102 Remote Control

IR Sensor

Up to 21' Cable

6' Cable

Power Supply

Control System/PC

SW6 VGA Ars Switcher

A typical IR 102 Kit application

The IR 102 remote receiver connects via cable to the switcher’s
rear panel RS-232 connector, and it uses the switcher’s RS-232
interface for input selection. The remote receiver also has an
RS-232 input connector to permit the switcher to be controlled
by a computer or control system, regardless of whether the
switcher’s RS-232 port is occupied by the IR 102 remote receiver.

N

The remote control can operate a switcher only if the
switcher is confi gured as master, with no switchers
slaved to it. Refer to the switcher’s manual for
information on switcher confi guration.