Front panel connectivity, Step 2 - route and organize cables under the table – Extron Electronics HSA 300 Hideaway User Manual
Page 4
4
68-2484-50
Rev. B
04 14
Extron Headquarters
+800.633.9876 Inside USA/Canada Only
Extron USA - West
Extron USA - East
+1.714.491.1500 +1.919.850.1000
+1.714.491.1517 FAX
+1.919.850.1001 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron
Middle East
+971.4.299.1800
+971.4.299.1880 FAX
Extron Korea
+82.2.3444.1571
+82.2.3444.1575 FAX
Extron India
1800.3070.3777
Inside India Only
+91.80.3055.3777
+91.80.3055.3737 FAX
©
2014 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners.
Front Panel Connectivity
The image at right shows the front panel of the HSA 300.
A. AC power outlet — Plug a standard power cord into this connector
to provide AC power for a laptop or other device. The power output
is the same voltage and frequency as the power input.
NOTE:
The Multi-Region AC outlet is fully compatible with
Europlug, Indian, Danish, and Italian plug types. See the
Multi-Region AC Outlet Compatibility Guide on the Extron
website,
www.extron.com
, for compatibility details on all
plug types.
B. USB power LED — This LED lights green when power is available.
C. USB power outputs — Connect USB-powered devices for charging.
D. Computer video input — Plug the VGA-UXGA output from a
computer into this 15-pin HD female connector.
E. Audio input connector — Plug a 3.5 mm stereo plug into this jack for unbalanced audio input.
F. RJ-45 connector — Plug a CAT 5 or CAT 6 twisted pair (TP) cable into this RJ-45 female connector for network, data, or
communication connection.
NOTE:
•
If necessary, on the front panel, replace the connector icon by prying the existing
icon off of the connector plug-in with a Tweeker and snapping the appropriate
icon in place (see the image at right).
•
To change to a different color connector bezel, replace the connector bezel
plug-in on the front panel with a bezel of a different color. If a connector is not
needed, replace the connector bezel plug-in with a blank plug-in.
G. HDMI input — Connect an HDMI source device to this HDMI connector.
Icon Label
VGA IN
AUDIO IN
HDMI IN
HSA 300
USB CHARGER
125V 50-60Hz 12A MAX
E
A
B
C
D
G
F
ATTENTION:
Allow approximately 1 inch of
cable length to protrude from the metal plate
before bending the cables for routing. The
cables can become damaged over time if they
are bent against the edges of the plate.
ATTENTION:
Laissez dépasser les câbles
d’environ 2,54 centimètres (1 inch) au-dessous
de la plaque en métal avant de les plier. S’ils
sont pliés contre les bords de la plaque, les
câbles peuvent s’endommager au fil du temps.
Zip tie holes
Step 2 - Route and Organize Cables
Under the Table
NOTE:
Make sure the lid of the HSA is open
while securing and routing the cables. If
the lid is closed during routing, the cables
attached to the front panel can restrict the
lid from opening.
If necessary, use zip ties to secure the
cables to the zip tie holes (see the image
at right).