Extron Electronics Hideaway Surface Access Products User Manual
Hideaway, Surface access products • installation guide, Planning
HSA 402
AUD
IO
PHONE
DATA
125 - 50/60 Hz 5A
PHONE
125 - 50/60 Hz 5A
HSA 402
DATA
1
Hideaway
®
Surface Access Products • Installation Guide
This guide provides instructions for an experienced installer to install and connect the
Extron HSA 400, HSA 402, and HSA 822.
The HSA units are lift-up architectural solutions for inconspicuous A/V connectivity access,
control, and AC power.
Planning
Determine the best location for the enclosure. Before making any cuts:
c
Ensure that the location where the HSA is to be installed is convenient
for as many users as possible.
c
Ensure that the edge on which the HSA opens is oriented correctly.
c
Ensure that there is ample space under the table for cables.
c
Ensure that the correct template or dimensions are used.
Decide on the method for cutting the hole in the table.
c
Hand router and template
c
CNC wood router
c
Jigsaw and paper template
Before starting the installation, check with local and state regulations:
c
Ensure that the planned installation complies with building
and electrical codes.
c
Ensure that the planned installation complies with the Americans with Disabilities Act or other accessibility requirements.
Tools and Equipment Required for Installation
Safety Glasses
Screw Driver
Tape Measure
Vacuum Cleaner
7/16" Hex Nut Driver or Wrench (US)
10 mm Hex Nut Driver or Wrench (Int’l)
1/4" Hex Nut Driver (for AAPs)
Marking Pen
Square
Included Parts
HSA 400
HSA 402
Clamshell Bolts
(4) sets of (2)
(various lengths)
HSA 822
COMPUTERAU
DIO
125 - 5
0/60 H
z 5A
HSA 40
0
125 - 50/60 Hz 5A
125 - 50/60 Hz 5A
HSA 40
2
Allen Wrench
(included with HSA 400
and HSA 402 only)
Zip Ties
Icon Kit
Bezel Kit
Tweeker (1)
CAT6
CAT6
CAT6
CAT6