Command and response table for sis commands, Fox extender program, Installing the software – Extron Electronics FOX DA8 User Guide User Manual
Page 16: Command and response table for, Sis commands, Command and response table
Command and Response Table for SIS Commands
Command
ASCII Command
(host to unit)
Response
(unit to host)
Additional Description
Channel Mute
NOTE:
The channel mute commands mute the data on the output only. The output continues to emit light.
Mute output
X!
*1B
Vmt
X!
*1
]
Blank data on optical output
X!
.
Unmute output
X!
*0B
Vmt
X!
*0
]
Output data on optical output
X!
.
Show video mute status
X!
B
X@]
Output
X!
data output mute status is
X@
(0 = unmuted, 1 = muted).
Mute all outputs
1*B
Vmt1
]
Blank data on all optical outputs.
Unmute all outputs
0*B
Vmt0
]
Output data on all optical outputs.
Show mute status of all outputs
E
VM
}
X@
1
X@
2
X@
3
X@
4
...
X@
8
]
Show output 1 through output 8 mute
status.
Information Requests
Information request
I
V01X08•A00X00
]
V01X08 shows the number of available
inputs (1) and outputs (8) for this product.
A00X00 has no meaning for this product.
Show firmware version
Q
X#]
Example:
Q
1.23
]
The factory-installed FOX DA8 controller
firmware version is 1.23 (sample value only).
Request part number
N
60-927-nn
]
nn indicates the transmission mode.
01 = multimode, 02 = singlemode.
Show input connections status
0LS
X$]
0000000 = no light on the input,
10000000 = light received.
Show temperature
20S
X%]
X%
= degrees Fahrenheit.
Show transceiver module status 0*1I
X^
1
X^
2
X^
3
X^
4
...
X^
8
]
Show all installed transceiver modules.
0 = none, 1 = multimode, 2 = singlemode.
FOX Extender Program
The Extron FOX Extender program, which communicates with the FOX DA8 via the rear
panel RS-232 port or front panel Config port of the unit, provides an easy way to operate
the DA8.
The program is compatible with Windows 2000, Windows XP, or later. Updates to this
program can be downloaded from the Extron website (
www.extron.com
).
Installing the Software
The program is contained on the Extron Software Products DVD. Install the software as
follows:
1.
Insert the DVD into the drive. The installation program should start automatically. If it
does not self-start, run
Launch.exe
from the DVD.
2.
The Extron software DVD window appears (see
Extron FOX DA8 • Remote Control
10