Installation and operation, Rear panel features – Extron Electronics FOX DA8 User Guide User Manual
Page 10
Installation and
Operation
The topics covered in this section are:
z
z
z
Rear Panel Features
FOX DA8
OPTICAL OUTPUTS
INPUT
OUT IN
1
OUT N/A
2
OUT N/A
3
OUT N/A
4
OUT N/A
5
OUT N/A
6
OUT N/A
7
OUT N/A
8
100-240V 0.3A
50/60 Hz
RS-232
Tx Rx
4
1
2 3
3
3
3
3
3
3
3
Figure 2.
FOX DA8 Connectors
WARNING: This unit outputs continuous invisible light, which may be harmful and
dangerous to the eyes; use with caution. For additional safety, plug the
attached dust caps into the optical transceivers when the fiber optic cable
is unplugged.
NOTES:
•
Singlemode and multimode devices are not interchangeable. Ensure that you
connect transmitting and receiving devices that are compatible with the
FOX DA8.
•
Ensure that you use the proper fiber cable for your system. Typically,
singlemode fiber has a yellow jacket and multimode cable has an orange
jacket.
•
In this guide, the term “sending connector” refers to an LC connector on a
device that outputs a fiber optic signal. The term “receiving connector” refers
to an LC connector that receives an optical signal.
a
AC power connector — Plug a standard IEC power cord into this connector to connect
the FOX DA8 to a 100 VAC to 240 VAC, 50 or 60 Hz power source.
Extron FOX DA8 • Installation and Operation
4