Extron Electronics CPM208 - Manual (Page 7)

CMP200 and CMP208 • Installation
Installation
CMP200 and CMP208 • Installation
Installation Overview
Install and set up a CPM modular A/V connector bay as
follows:
1 Draw a mounting template, based on the surface cut-out
dimensions shown in the back of this guide
(see Appendix A).
2 Place the template where you want the enclosure installed,
and mark the surface material to be removed.
3 Cut a hole in the surface where the enclosure will be
installed and install the enclosure. The screw clamps
secure the enclosure to the tabletop. See "Preparing the
Table and Installing the CPM Enclosure" in this chapter.
4 Run all cables necessary to support the MAAP panels/
modules. Leave enough slack in the cables to connect
them to the underside of the enclosure.
5 Turn off all of the equipment to be connected. Ensure
that all the equipment connected to the MAAP modules is
turned off and disconnected from the power source.
6 Install the MAAPs and connect the cables to the MAAPs.
See "Installing the MAAPs and the Cables" in this chapter.
7 Connect power cords and turn on the devices that connect
to the connector bay.
Preparing the Table
To install either enclosure, you can use a paper cut-out template
(see Appendix A) and a saber or keyhole saw to remove the
surface material. Alternately, if you are installing a CPM200
unit, a 3.5” hole saw may be used to prepare the table instead of
a saber or keyhole saw.
Prepare the table as follows:
CAUTION The opening in the table for the CPM200 or
CPM208 should be cut only by licensed and bonded
craftspeople. Exercise care to prevent scarring or
damaging the furniture.
The surfaces of the CPM enclosure have screws and
other protruding hardware that could damage fine
furniture. Do not rest the enclosure on unprotected
furniture.
2-2 2-3
Preparing the table with a saber or keyhole saw
1. Using the dimensions for your enclosure provided in the
back of this manual (see Appendix A), draw an installation
template.
2. Locate the desired mounting location on the tabletop or
other installation surface and, using the template, draw an
outline of the surface material to be removed. If necessary,
use a square to ensure that the template is properly
positioned. Extron is not responsible for improperly
positioned CPM products.
3. Using a saber saw or keyhole saw, carefully cut the
opening in the table surface.
Wear safety glasses when operating the saber saw.
Failure to comply can result in eye injury.
Preparing the table with a hole saw (CPM200 only)
1. Locate the desired mounting location on the tabletop or
other installation surface. Mark the 3.5” circle, then find
the center and mark it as well.
Wear safety glasses when operating the hole saw.
Failure to comply can result in eye injury.
2. Using a 3.5” hole saw on a portable drill, cut the mounting
hole at the desired location. Extron is not responsible for
improperly positioned CPM products.
CAUTION Use a portable drill with sufficient power to handle
the 3.5” hole saw. Exercise caution when handling
the drill and hole saw. Care should be taken to
protect the tabletop, podium, or other mounting
surface from damage.
Figure 2-1 — Cutting the opening with a hole saw