Extron Electronics CPM208 - Manual (Page 10)

CMP200 and CMP208
CPM200 and CPM208 • Maintenance and Modifications
Maintenance and Modifications
A
Appendix A
Reference Information
Specifications
Top Plate Dimensions
CPM Part Numbers
3-2
Removing and Replacing the Enclosure
Remove and replace the CPM enclosure for maintenance as
follows:
Ensure that any AC power (if connected) is
disconnected before removing the CPM unit.
1. Loosen and remove the screws holding the MAAP module
in the CPM enclosure.
2. Gently pull the MAAP module, with the cables attached,
out of the CPM enclosure.
3. Remove the cables from the MAAPs.
4. On the underside of the table, loosen the mounting
brackets holding the enclosure to the tabletop. Remove the
brackets.
5. Lift the enclosure out of the table.
The surfaces of the CPM enclosures have screws and
other protrusions that could damage fine furniture. Do
not rest the enclosures on unprotected furniture.
6. Perform the desired maintenance procedure.
7. Carefully lower the CPM enclosure into the table opening.
From the underside, reattach the mounting brackets to the
enclosure, then tighten the brackets, securing the enclosure
to the tabletop.
8. Reconnect the cables to the MAAPs.
9. Reinstall the MAAPs onto the MAAP shelf in the CPM
enclosure (see "Installing the MAAPs and the Cables" in
chapter 2, Installation).
Replacing Cables or an MAAP
Before you change the cables inside the CPM unit or replace one
or more MAAPs, you must remove the MAAP from the CPM
enclosure. Use the following guidelines as applicable:
1.
Remove the MAAP by removing the two hex mounting
screws securing the MAAP to the MAAP shelf in the
enclosure.
2. Gently push the MAAP (with the cable attached) out
through the top of the enclosure.
3. Once the MAAP is removed, you can change the cables
and/or MAAPs as required. See "Installing the MAAPs
and the Cables" in chapter 2, Installation.
4. Reinstall the MAAP module into the CPM enclosure.