Extron Electronics 3G HD-SDI 101 User Guide - Manual (Page 9)

3G HD-SDI 101 • Installation and Operation 5
Furniture mounting
The 3G HD-SDI 101 can be mounted under furniture using
optional mounting kit MBU 125 (part # 70-077-01) as follows:
1. Attach the mounting brackets to the 3G HD-SDI 101 with the
provided machine screws as shown in the figure below.
2. Hold the 3G HD-SDI 101 with the attached brackets against
the underside of the table or other furniture. Mark the
location of the screw holes in the brackets on the mounting
surface.
3. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep
in the mounting surface at the marked screw locations.
4. Insert #8 wood screws into the four pilot holes. Tighten each
screw into the mounting surface until just less than 1/4" of
the screw head protrudes.
5. Align the mounting screws with the slots in the brackets and
place the 3G HD-SDI 101 and brackets against the surface,
with the screws through the bracket slots.
6. Slide the 3G HD-SDI 101 slightly forward or back, then
tighten all four screws to secure the unit in place.
Mounting the 3G HD-SDI 101 under a desk